Abstract:In view of the fact that the partial discharge (PD) signal energy is mainly concentrated below hundreds of megahertz, the ultra-high frequency part of the energy is weak, and the interior space of the switchgear is narrow, this paper proposes a new method for PD detection of the switchgear based on near-field detection. Firstly, based on the principle of PD, the field characteristics of the signal in the switchgear are analyzed. After that, the probe is designed with an electric small loop structure. Based on its equivalent circuit, its measurement principle and amplitude frequency characteristics are analyzed. The influence of probe size and material on amplitude frequency characteristics is obtained by using simulation software High Frequency Structure Simulator (HFSS), and the probe parameters suitable for PD detection in the switchgear are determined. Finally, the performance of the probe is measured by network analyzer, and the PD signal is tested on the simulated PD test platform. The results show that the probe works in the frequency band of 10–200 MHz and can receive PD signals containing more energy information. In the operating frequency band, the reflection coefficient of the probe port is very large, and its interference to the signal near field is particularly small. The probe also has good frequency response characteristics, and the fluctuation in the frequency band is less than 5 dB, which can obtain more accurate PD signal characteristics in subsequent processing. In addition, the probe is passive, with dimensions of 166 mm in length, 104 mm in width, and 2 mm in thickness, which is suitable for placing in the switchgear with small internal space. The results of PD receiving test show that the probe can reflect the occurrence of PD remarkably and accurately.

Research on Partial Discharge Monitoring System of Switchgear Based on Wireless Distributed TEV Sensors

Efficient and Low-Cost PD Monitoring and Locating System for MV Switchgears Using TEV Detectors

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Partial discharge detection, diagnosis, and location technology based on a novel transient earth voltage-ultrasonic integrated sensor used for switchgear equipment

Passive Wireless Partial Discharge Sensors with Multiple Resonances

Computation of Transient Electromagnetic Field Emission from Enclosure During GIS Disconnector Switching Operations

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

Review of research on partial discharge detection techniques of high voltage switchgear

Examination and Research on the Partial Discharge Fault Diagnostics in Gas Insulated Switchgear

On-line Partial Discharge Monitoring and Diagnostic System

Research on Partial Discharge Detection of Switchgear Based on Ultrasonic Signal Characteristic

Flexible Sensor Array Based on Transient Earth Voltage for Online Partial Discharge Monitoring of Cable Termination

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS

Diagnosis of Insulation Condition of MV Switchgears by Application of Different Partial Discharge Measuring Methods and Sensors

RESEARCH AND DEVELOPMENT OF ON-LINE MONITORING SYSTEM WITH PARTIAL DISCHARGE IN XLPE POWER CABLES

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

Partial discharge detection on power equipment using a magneto-resistive sensor

Comparison of Pd Detection Methods for Power Transformers - Their Sensitivity and Characteristics in Time and Frequency Domain

A Review of Techniques for RSS-Based Radiometric Partial Discharge Localization

Detection and Identification Technologies of Wide Band Partial Discharge