Abstract:Surface acoustic waves (SAWs) are of practical importance across several fields. Particularly, a wide range of SAW devices is available, which are based on the stacking piezoelectric layered hetero-structures. As such, efficient and stable algorithm of analyzing electromechanical coupling factor (K2) should be of specific interest, inspiring a variety of piezoelectric layered structures. Motivated by the above considerations, this paper exploits the performance of Sc43% AlN57%/ZnO/diamond piezoelectric hetero-structures using matrix and polynomial methods. Consequently, dispersion curves, the electromechanical coupling factor and profiles of Rayleigh waves are calculated, in which the properties of hexagonal intermediate ZnO layer are varied. Here, $$ (0001) - [10\bar{1}0]{\text{ZnO}} $$ or $$ (11\bar{2}0) - [0001]{\text{ZnO}} $$ directions of the middle layer were integrated with Sc43% AlN57%/diamond to be a composite hetero-structure with a larger K2 of SAW. Accordingly, a commercial ZnO specimen was characterized by scanning electron microscopy (SEM) as well as Raman and XRD spectroscopy to determine its available crystallographic directions and the C-axis hexagonal character. Comparing with conventional AlN/diamond hetero-structures, the inclusion of ZnO as the intermediate layer provides with an excellent electromechanical coupling factor which significantly improves the $$ (11\bar{2}0) - [0001] $$ structure. However, comparing with the ZnO/diamond hetero-structure, a high phase velocity (Vph) was observed. Therefore, the development of a well-balanced structure that maximizes the values of Vph and K2 is systematically challenging. Moreover, it was found that initial stresses have a significant effect on the Rayleigh wave velocities. Fundamental A0 Lamb mode can be generated in piezoelectric hetero-structures when the properties of substrate remain very low relative to the film. Numerical results obtained in this paper can provide a deeper insight into the nature of the Rayleigh wave behaviors in piezoelectric hetero-structures, involving a ZnO intermediate layer.

Solidly Mounted Resonators Fabricated for GHz Frequency Applications Based on MgxZn1-xO Piezoelectric Film

Lateral Field Excitation of Thickness Longitudinal Mode and Shear Mode with ZnO Based on Solidly Mounted Resonator

Magnetron Sputtering of ZnO Thick Film for High Frequency Focused Ultrasonic Transducer

Pulsed-laser deposition of piezoelectric-coefficient modulated multilayered films ZnO/Al2O3 on silicon and their enhanced acoustic resonance

Novel Design and Performance of the Solidly Mounted Resonator with an AlN-buffered ZnO Piezoelectric Film

Preparation of Piezoelectric-Coefficient Modulated Multilayer Film ZnO/Al2O3 and Its Ultrahigh Frequency Resonance

Process Optimization and Device Variation of Mg-doped ZnO FBARs

Preparation and Performance Study on Mg-doped ZnO Solid Mounted Film Bulk Acoustic Resonator

V-Doped Zno Thin Films Prepared by Rf Magnetron Sputtering

Material and Device Properties of ZnO-based Film Bulk Acoustic Resonator for Mass Sensing Applications

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Ultra flexible pseudo-lamb wave RF resonators based on ZnO/PI and AlN/PI structures

Fabrication and characterization of zinc oxide piezoelectric MEMS resonator

High frequency lithium niobate film-thickness-mode optomechanical resonator

Influence of a Piezoelectric ZnO Intermediate Layer on Rayleigh Waves Propagating in Sc 43% AlN 57% /zno/diamond Hetero-Structures Subjected to Uniaxial Stress

Lateral Extensional Mode Piezoelectric ZnO-on-Nickel RF MEMS Resonators for Back-End-of-Line Integration

Solidly Mounted Resonators with Ultra‐High Operating Frequencies Based on 3R‐MoS2 Atomic Flakes

Bulk acoustic wave resonance characteristic modified by reducing the defects in ZnO-based solidly mounted resonators

Epitaxial ZnO piezoelectric layer on SiO 2 /Mo solidly mounted resonator fabricated using epitaxial Au sacrificial layer

Characteristics of one-port surface acoustic wave resonator fabricated on ZnO/6H-SiC layered structure

ε‐Ga2O3: An Emerging Wide Bandgap Piezoelectric Semiconductor for Application in Radio Frequency Resonators