Automatic Respiratory Gating of Tof-Pet Data Using Time-Of-Flight Information

Mengdie Wang,Ning Guo,Joshua Schaefferkoetter,Jianhua Yan,Guangshu Hu,Hui Zhang,Georges El Fakhri,Quanzheng Li
2015-01-01
Journal of Nuclear Medicine
Abstract:427 Objectives Traditional data-driven respiratory gating method is capable of detecting breathing cycles directly from high SNR PET data, but usually fails at low SNR, particularly at low dose PET/CT study. Here we present a robust data-driven respiratory gating method using TOF information. Methods A 5 min chest PET/CT scan was performed 90min after injection of 6mCi 18F-FDG in a human subject. TOF PET list-mode data with 580ps time resolution was stored and the bellow data was acquired simultaneously using Anzai AZ-733 system. The TOF list-mode data was split into sinograms with 0.1s duration and binned to nonTOF sinograms using FORET method [1] while keeping the SNR improvement. Single Slice Rebinning was performed to calculate the center of mass and the respiratory signal was derived, similar to the nonTOF method. Both extracted signals were processed using same Gaussian bandpass filter. Robustness was assessed using correlation and errors between the data-driven triggers (TOF and nonTOF) and bellow signal. The total signal power was evaluated between the presented and nonTOF method. Results Although both TOF and nonTOF triggers agreed with the bellow (correlation 0.99 and 0.98, respectively), a better SNR and stronger respiratory component were achieved in the signal obtained with TOF information. The errors of the TOF (nonTOF) PET data derived triggers with respect to bellow triggers (end-inhalation) was 0.24±0.27 (0.34±0.30) sec. Spectral analysis confirms that the respiratory motion derived using TOF information outperformed the nonTOF method with the total respiratory signal power in percent (TP%) of 55.21% vs 23.33%. Conclusions Automatic respiratory gating using TOF sinograms outperforms the nonTOF method due to additional SNR improvement in TOF information. More thorough evaluation are underway to quantify the improvement at different noise levels.
What problem does this paper attempt to address?