Abstract:Though analyzing the structure characteristics of arbitrary n-polygon non-circular sections, the mathematical formulas among the characteristic parameters were set up, and the theorem for designing this kind of sections was deduced by mathematical induction method. Based on mechanistic transmission principle, the control theorem for the numerical control (NC) grinding of arbitrary n-polygon non-circular sections and the control model for the multi-coordinate motion were built. The real-time interpolation algorithm was presented based on central angle division, and the method of acceleration-deceleration according to the curvature of surface was given. The dynamic model of the AC position servo system of grinding n-polygon non-circular sections is set up by experiment identification, and its parameter adjustment method is also studied. Then a feedforward control strategy is analyzed systematically, the tracking performance and contour error of the feedforward tracking controller for grinding n-polygon non-circular sections were deeply studied on the view of qualitative and quantitative analysis, the results show that the feedforward tracking control method is good in contour tracking and precision. Then a NC machine tool for grinding n-polygon non-circular sections was developed. The test results of the grinded parts showed that the section profiles accorded to the design demands; the roughness was less than 0.32 μm and the dimensional accuracy was within 8 μm. The results prove that the proposed theorems and method can effectively direct the design and manufacture of the polygonal non-circular connection.

Accuracy Control of Ballig of Crankshaft Journals in Grinding Process Based on Cutting Depth Model

An Intelligent Prediction of Surface Roughness on Precision Grinding

Measurement and Technological Test on Grinding State Parameters of Bearing Ring Raceway

Error Compensation in One-Point Inclined-Axis Nanogrinding Mode for Small Aspheric Mould

Research on the key technique for numerical control grinding arbitrary n-polygon shafts

Research on the System Matching Model in Ultrasonic Vibration-Assisted Grinding

Control Strategy of Crankshaft Tangential Point Tracing Grinding and Error Analysis

The development of time-dependent compensation model for roller CVC profile generation in precision grinding

An Analysis Method of Oscillating Grinding Motion Model for Crankshaft Pin Journal.

Precise Alignment Method of the Large-Scale Crankshaft During Non-Circular Grinding

Research on the precision machining of CVD rotary dressers based on graded grinding and real-time profile planning path of grinding wheel

Accuracy Control of the Jig Needle Bar Based on FEA

Dimensional Accuracy Compensation Method of Large Shaft Grinding Via Residual Error Iteration with Fuzzy Approach

Process Monitoring in Precision Cylindrical Traverse Grinding of Slender Bar Using Acoustic Emission Technology

Computerised grinding procedure for large scale crankshaft machining

Research on straightness error detection and quality control of multi-crankshaft bores for large medium speed engine block

Modeling and Simulation of Grinding Surface Topography Considering Wheel Vibration

Development of an oscillating grinding machine tool based on error analysis

Online dressing of profile grinding wheels

A high-precision fitting and dressing method for the flex and circular rigid splines with involute tooth profile in gear form grinding

Modelling and Analysis of Grinding Energy Consumption in Non-circular Grinding Process