Abstract:Though analyzing the structure characteristics of arbitrary n-polygon non-circular sections, the mathematical formulas among the characteristic parameters were set up, and the theorem for designing this kind of sections was deduced by mathematical induction method. Based on mechanistic transmission principle, the control theorem for the numerical control (NC) grinding of arbitrary n-polygon non-circular sections and the control model for the multi-coordinate motion were built. The real-time interpolation algorithm was presented based on central angle division, and the method of acceleration-deceleration according to the curvature of surface was given. The dynamic model of the AC position servo system of grinding n-polygon non-circular sections is set up by experiment identification, and its parameter adjustment method is also studied. Then a feedforward control strategy is analyzed systematically, the tracking performance and contour error of the feedforward tracking controller for grinding n-polygon non-circular sections were deeply studied on the view of qualitative and quantitative analysis, the results show that the feedforward tracking control method is good in contour tracking and precision. Then a NC machine tool for grinding n-polygon non-circular sections was developed. The test results of the grinded parts showed that the section profiles accorded to the design demands; the roughness was less than 0.32 μm and the dimensional accuracy was within 8 μm. The results prove that the proposed theorems and method can effectively direct the design and manufacture of the polygonal non-circular connection.

Control Strategy of Crankshaft Tangential Point Tracing Grinding and Error Analysis

Research on the key technique for numerical control grinding arbitrary n-polygon shafts

Error Modeling and Force Effects Analysis on Crankshaft Pin Diameter in Path Controlled Grinding

Research on Control Method for Machining Non-Cylinder Pin Hole of Piston

Accuracy Control of Ballig of Crankshaft Journals in Grinding Process Based on Cutting Depth Model

Crankshaft roundness tracing measurement strategy in noncircular grinding process

Research On The Key Technologies Of Cnc Noncircular Camshaft Grinding

Design of Robust Grinding Wheel Reciprocating Arrangement for Precision Point-Grinding Machining

Three-sensor Tracing Principle for Crankshaft Roundness Error Measurement During Noncircular Grinding Process

Development of an oscillating grinding machine tool based on error analysis

Revolution Control Of Headstock Base on Cam Non-circular Grinding

Optimization of Roughness and Residual Stresses in Path Controlled Grinding of Crankpin

Research on Surface Tracking and Constant Force Control of a Grinding Robot

Grinding performance in crankshaft pin journal path-controlled grinding of 40Cr using CBN wheel

An Analysis Method of Oscillating Grinding Motion Model for Crankshaft Pin Journal.

Precise Alignment Method of the Large-Scale Crankshaft During Non-Circular Grinding

Vibration Analysis for Tangent Point Tracing Grinding Process of Cam

Research on Error Modeling and Influence Factors of Crank Radius

The Development of Automatic Programming System for Tracing Grinding at Crankshaft Tangential Point

Calculation of the Force Distortion in Non-Circular Crankshaft Grinding with Four-Point Rigidity Method

A Method to Control the Deformation of Main Journals in Grinding Process