Dynamic recrystallization and twinning behavior of magnesium alloy during hot tension
Xiong Xu,Huihui Nie,Jun Zhou,Hongyang Zhang,Zhijian Li,Yangyang Yang,Hongsheng Chen,Tiantian Yang
DOI: https://doi.org/10.1016/j.jmrt.2023.05.056
IF: 6.267
2023-05-11
Journal of Materials Research and Technology
Abstract:In this study, {10-12} tensile twins (TTs) were induced in hot-rolled AZ31 Mg sheets via hot tension along the normal direction. The results demonstrate that the volume fraction of TTs at 2mm/min is greatly lower than their counterparts at 0.5mm/min at 100°C and 200°C. Dynamic recrystallization (DRX) can decrease twin nucleation rate during hot tensile when the strain rate reaches 2mm/min. Decrease in critical resolved shear stress of non-basal slips at 200°C enhances the deformation capability among grains, which dramatically reduces the volume fraction of TTs. Hence, TTs are hardly observed in 200°C-2mm/min sample. Tensile temperature significantly affects the morphology of TT lamellae. Grain boundaries prevents the longitudinal growth of the TTs, and then the thickness of TTs begins to grow to coordinate the deformation, resulting in fine TT lamellae in 100°C-0.5mm/min. Compared with AR, the basal texture intensity of 100°C-2mm/min and 200°C-2mm/min increases and the occurrence of DRX is the main reason, while basal texture weakening of 100°C-0.5mm/min and 200°C-0.5mm/min depends on the formation of TTs. Compared with samples at 200°C, the samples at 100°C have higher tensile stresses. The maximum stress of 100°C-0.5mm/min is 64.97 MPa when tensile strain reaches 0.15 owing to its highest dislocation density. 200°C-2mm/min possesses the highest hardness among the four tension samples, which is associated with the largest fraction of DRXed grains (68.8%) and its refinement strengthening effect. Dislocation strengthening exerts more influence on the hardness of 100°C-0.5mm/min.
materials science, multidisciplinary,metallurgy & metallurgical engineering