Abstract:ABSTRACTDeveloped more than 80 years ago, the design procedure of concrete filled steel tubes (CFST) has several limitations that can still be found in most current international design standards. The two main limitations that present themselves are the lack of ability to achieve material enhancement when using high strength materials and restrictions on the geometry of the steel tube thickness to the overall column diameter. This geometric limitation is placed on the design to ensure that the steel tube remains ‘compact’. In complying with these constraints it is assumed in the design equations that local buckling of the steel tube will not take place before the ultimate global buckling load is achieved.With the introduction of higher strength materials, specifically when dealing with steel, the strength increase leads to the design of sections with increased slenderness. As the section becomes more slender, the ability to maintain the compact section limitations in the design codes becomes increasingly difficult. This paper looks at an experimental study on very thin‐walled steel tubes filled with high‐strength concrete and how localised buckling affects their compressive capacity.Adopting a diameter to thickness ratio of 200, 24 circular tubes were constructed using a high‐strength cold‐formed steel sheet, with yield stresses above 500MPa and filled with 100MPa concrete. Employing both thin‐walled sections and high strength materials, the effects of localised buckling in these composite members when subjected to compression has been studied. The experimental programme explored four main conditions; when both the steel and concrete were loaded and bonded together, when the concrete core inside the CFST was loaded, when the steel tube in the CFST was loaded and when the concrete core without the steel tube was tested.By studying the failure modes of both the concrete and the steel tube when acting compositely and individually, the experimental work shows that there is valid evidence to support the theory that even when using high strength materials in slender sections, confinement to the concrete core is provided. Finally, the results of the experimental work have been compared to the compressive design capacities predicted by current international design codes, showing that these provisions are conservative.

Experimental Behavior of Circular Flyash-Concrete-filled Steel Tubular Stub Columns

Experimental Study on Axial Compressive Behavior of Concrete-Filled Corrugated Steel Tubular Columns

Experimental investigation of concrete-filled steel tubular columns with reinforcing lattice angle

Experimental investigation of self-compacting concrete-filled weather steel tube stub columns

Combined Axial and Flexural Behavior of Concrete-Filled Corrugated Steel Tubular Columns

Experimental investigation of thin-walled concrete-filled steel tube columns with reinforced lattice angle

Axial compression performances and bearing capacity prediction of self-compacting fly ash concrete filled circle steel tube columns

Numerical Simulation of Axially Loaded Circular Steel Tubular Stub Columns with Fly Ash Concrete Infill

Investigation on axial compression performance of self-compacting fly ash concrete filled square steel tube column: Tests and numerical simulation

Experimental Studies On The Strength With High Slenderness Ratio Concrete Filled Steel Tubular Columns

08.17: Experimental Behaviour of High‐strength Thin‐walled Concrete Filled Steel Tubular Stub Columns

Performance of square steel tubular stub columns in-filled with fly ash and silica fume self-compacting concrete under concentric loading

Behaviour of CFRP-confined Concrete-Filled Circular Steel Tube Stub Columns under Axial Loading

Experimental Behaviour of Concrete-Filled Stiffened Thin-Walled Steel Tubular Columns

High strength steel square and rectangular tubular stub columns infilled with concrete

Behaviors of FRP confined rectangular concrete-filled thin-walled steel tubular stub columns using high-strength materials under axial load

Experimental behaviour of recycled aggregate concrete filled steel tubular columns

Experimental and numerical study on self-compacting alkali-activated slag concrete-filled steel tubes

Experimental Research of FRP Composite Tube Confined Steel-reinforced Concrete Stub Columns Under Axial Compression

Axial compressive behavior and confinement mechanism of circular FRP-steel tubed concrete stub columns

Analytical and experimental investigation on axial compression capacity of carbon fiber-reinforced plastic-confined concrete-filled double-skin steel tube stub columns