Abstract:Heat assisted magnetic recording (HAMR) is a new technology which uses temporary near field laser heating of the media during write to increase hard disk drive storage density. By using plasmonic antenna embedded in the write head, extremely high thermal gradient are created in the recording media (up to 10K/nm). State of the art HAMR media consists of grains of FePtX ordered alloys exhibiting high perpendicular anisotropy separated by insulating grain boundaries. Nearby the plasmonic antenna, the difference of temperature between two 8nm wide neighboring grains in the media can reach 80K, representing a gigantic thermal gradient of ~40K/nm across the grain boundary. Such situations with much weaker thermal gradient (~1K/nm, already considered as very large) have already been studied in the field of spincaloritronics. There, it was shown that very large spin transfer torques due to thermal gradients can arise in magnetic tunnel junctions which can even yield magnetization switching. Considering that two neighboring grains separated by an insulating grain boundary in a HAMR media can be viewed as a magnetic tunnel junction and that the thermal gradients in HAMR are one to two orders of magnitude larger than those existing in conventional spincaloritronics, one may expect a major impact from these thermal torques on magnetization switching dynamics and therefore on HAMR recording performances. This paper combines theory, experiments aiming at determining the polarization of tunneling electrons across the media grain boundaries, and micromagnetic simulations of recording process. It is shown that the thermal in-plane torque can have a detrimental impact on the recording performances by favoring antiparallel magnetic alignment between neighboring grains during the media cooling. Implications on media design are discussed in order to limit the impact of these thermal torques.

Influence of Exchange on Signal-to-noise Ratio in [cox/pt]4 Media

MAMR Frequency Selection on [cox/pt]4 Media

Optimum Multilayer Anisotropy Distribution for Microwave-Assisted Magnetic Recording [cox/pt](n) Media

Micromagnetic Studies on Exchange Coupled Composite Recording Media

Magnetic Film Thickness Effects on the Recording Performance of Perpendicular Media

Micromagnetic Analysis of Transition Noise for High-Density Perpendicular Recording

Micromagnetics Studies of CoX/Pt Media with Interfacial Anisotropy Based on Voronoi Polycrystalline Structures

Micromagnetic Studies of Density Limit in Polycrystalline Recording Media

Design Consideration and Practical Solution of High-Performance Perpendicular Magnetic Recording Media

Micromagnetics Studies of CoX/Pt Media with Interfacial Anisotropy Based on Polycrystalline Structure Model Using Voronoi Tessellation Method

Improving the signal-to-noise ratio for heat-assisted magnetic recording by optimizing a high/low Tc bilayer structure

Improvement of Read Back Properties in Hdd with Prml Signal Processing Method

AC noise reduction based on exchange coupled grains for heat-assisted-magnetic recording: The effect of an FeRh interlayer

Studies of HAMR Recording by Hybrid Monte Carlo Micromagnetics

Dynamic Simulation of High-Density Perpendicular Recording Head and Media Combination

Impact of intergrain spin transfer torques due to huge thermal gradients on the performance of heat assisted magnetic recording

Impact of Media Design on Track Edge in Perpendicular Magnetic Recording

Effect of Anisotropy Field Magnitude Distribution on Signal-to-noise Ratio

Exchange coupled composite media for heat assisted magnetic recording

Manifestation of higher-order inter-granular exchange in magnetic recording media

Perpendicular Magnetic Anisotropy Dependence of Exchange Spin Resonance Mode for Ferrimagnetic GdCoFe Nanoscale Thin Films: Implications for High-Speed Spintronic Devices