Abstract:Heat assisted magnetic recording (HAMR) is a new technology which uses temporary near field laser heating of the media during write to increase hard disk drive storage density. By using plasmonic antenna embedded in the write head, extremely high thermal gradient are created in the recording media (up to 10K/nm). State of the art HAMR media consists of grains of FePtX ordered alloys exhibiting high perpendicular anisotropy separated by insulating grain boundaries. Nearby the plasmonic antenna, the difference of temperature between two 8nm wide neighboring grains in the media can reach 80K, representing a gigantic thermal gradient of ~40K/nm across the grain boundary. Such situations with much weaker thermal gradient (~1K/nm, already considered as very large) have already been studied in the field of spincaloritronics. There, it was shown that very large spin transfer torques due to thermal gradients can arise in magnetic tunnel junctions which can even yield magnetization switching. Considering that two neighboring grains separated by an insulating grain boundary in a HAMR media can be viewed as a magnetic tunnel junction and that the thermal gradients in HAMR are one to two orders of magnitude larger than those existing in conventional spincaloritronics, one may expect a major impact from these thermal torques on magnetization switching dynamics and therefore on HAMR recording performances. This paper combines theory, experiments aiming at determining the polarization of tunneling electrons across the media grain boundaries, and micromagnetic simulations of recording process. It is shown that the thermal in-plane torque can have a detrimental impact on the recording performances by favoring antiparallel magnetic alignment between neighboring grains during the media cooling. Implications on media design are discussed in order to limit the impact of these thermal torques.

Improving the signal-to-noise ratio for heat-assisted magnetic recording by optimizing a high/low Tc bilayer structure

Noise reduction in heat-assisted magnetic recording by optimizing a high/low Tc bilayer structure

AC noise reduction based on exchange coupled grains for heat-assisted-magnetic recording: The effect of an FeRh interlayer

Areal density optimizations for heat-assisted-magnetic recording of high density bit-patterned media

Fundamental limits in heat assisted magnetic recording and methods to overcome it with exchange spring structures

Dynamic Simulation of High-Density Perpendicular Recording Head and Media Combination

Micromagnetic Analysis of Transition Noise for High-Density Perpendicular Recording

Optimum Multilayer Anisotropy Distribution for Microwave-Assisted Magnetic Recording [cox/pt](n) Media

Heat-Assisted Magnetic Recording’s Extensibility to High Linear and Areal Density

Efficiently reducing transition curvature in heat-assisted magnetic recording with state-of-the-art write heads

Heat-assisted Magnetic Recording by a Near-Field Transducer with Efficient Optical Energy Transfer

Integrated Near Field Transducer Heat Assisted Magnetic Recording Head: Design And Recording Demonstration

Heat Assisted Magnetic Recording with Matching Media and Recording Head Field

A New Highly Anisotropic Rh‐Based Heusler Compound for Magnetic Recording

Impact of intergrain spin transfer torques due to huge thermal gradients on the performance of heat assisted magnetic recording

Analysis on the magnetic capping effect in heat assisted magnetic recording

Design Consideration and Practical Solution of High-Performance Perpendicular Magnetic Recording Media

Micromagnetic Modeling for Heat-Assisted Magnetic Recording

Stable ultrahigh-density magneto-optical recordings using introduced linear defects

Studies of HAMR Recording by Hybrid Monte Carlo Micromagnetics

Write head design for effective curvature reduction in heat-assisted magnetic recording by topology optimization