Palladium-Silica Organic-Inorganic Membrane Materials Via a Sol-Gel Process: Preparation and Properties Calcined under H2 Atmosphere

Jing Yang,Lin Yu Li,Hai Yun Hou,Zhi Tong
DOI: https://doi.org/10.4028/www.scientific.net/kem.727.889
2017-01-01
Key Engineering Materials
Abstract:Pd-doped SiO2 organic-inorganic membrane materials were prepared via a sol-gel process. The sol stability is characterized by sol particle size and zeta potential analysis. And the properties of the Pd-doped SiO2 organic-inorganic membrane materials are investigated by X-ray diffraction (XRD), fourier transform infrared (FTIR), energy dispersive spectrum (EDS) analysis and N2 absorption-adsorption measurement. The results showed that the sol particle size distributions are relatively narrow. With the increase of Pd content, the sol particle sizes slightly increase and the zeta potentials decreases until the palladium/tetraethylorthosilicate molar ratio closes to the isoelectric point. After calcined at 350 °C under H2 atmosphere, the added PdCl2 is reduced to metallic Pd0 completely, and the hydrophobic Si−CH3 groups exist in the SiO2 network. The Pd atoms have a lower concentration on the surface and more Pd atoms embedded in the SiO2 matrix. The Pd-doped SiO2 membrane materials calcined at 350 °C with a palladium/tetraethylorthosilicate molar ratio of 0.15 exhibit large BET surface area (up to 683.36 m2/g) and total pore volume (up to 0.386 cm3/g), as well as a mean pore diameter of about 2.26 nm.
What problem does this paper attempt to address?