Abstract:At present, the EMU in China adopts dispersive grounding system, which causes reflux current among grounding points and potential rising of car-body will threaten the safe operation of the EMU. The problem of EMU grounding attracts wide attention from relevant enterprises and universities, while now there are no uniform standards of EMU grounding all over the world. In this paper, a test of protective current waveforms was carried out and a model and overhead contact system of 380B EMU based on the AT power supply mode was established by Simulink software to study the distribution of protective current. The results show that the amplitude and phase of protective current change periodically due to the influence of mid-point connections and the period is about 20s. The amplitude of protective current gradually increases when train approaches the mid-point connections and subsequently gradually decreases when train departs from it. The max amplitude of protective current is 170A when first or last shaft of EMU goes through the mid-point connections. In addition, the phase of protective current relates to the position of the train, the holistic regularity is that when the EMU locates the middle during the mid-point connections, the current flows into the car body from the protective grounding of middle car and flows out from both that of No.1 car and No.8 car, when the EMU locates side of the mid-point connections, the current flows into the car body from the protective grounding which far away from the mid-point connections and flows out from the No.1 shaft of No.1 or No.8 car which near by the mid-point connections. Furthermore, adding a grounding resistance with 0.1Ω on the shaft of No.1 and No.8 car can reduce the amplitude of all protective currents effectively. The conclusions above could provide theoretical basis for designing better grounding schemes.

Influence of working grounding mode on grounding reflux in high-speed EMU

Influence of Protective Grounding on High-speed EMU Grounding Reflux

Analysis of Traction Reflux Characteristics of EMU and Improvement of Its Protective Grounding System

Study On The Optimization For Protective Grounding Scheme Of Crh380b Emu

Research on Protective Grounding Current Distribution of 380B EMU Based on AT Power Supply Mode

Modeling and Evaluation of Common-Mode EMI Coupling Through Converter Chassis in Metro Traction System

Electromagnetic Disturbed Mechanism of Electronic Current Transformer Acquisition Card under High Frequency Electromagnetic Interference

3D Modelling of an Integrated Grounding System for High-Speed Trains Considering Rail-Train Current Reflux

The Reflux Regulation Methodology of Adapting Transiently-varying Grounding Impedance for High-Speed Trains Based on Adjustable Resistance Technique

Influence of the Distributed Grounding Layout for Intercity Trains on the “train–rail” Circumflux

Influence Mechanism of the Mobile Grounding Reflux on the “Wheel-Rail” Rolling Arc at Insulated Joints of High-Speed Railway

Influence of Grounding Mode on Surge Voltage in the Process of Pantograph Rising for High Speed Train

Grounding Effect of Integrated Grounding Wire for High-Speed Railway

Modeling and Simulation at Temporary Power-off State of EMU Traction Driver System

Simulation Analysis of Grounding Characteristics of Cable Based on ATP-EMTP

The Grounding Current Suppression Measures for Subway via Changing Grounding Layout and Impedance

Modeling and Experimental Analysis of Overvoltage and Inrush Current Characteristics of the Electric Rail Traction Power Supply System

Research on Coordinated Control Method of PMSMs Traction System in EMU Train

lnfluence of high-speed railway cable grounding mode on the induced voltage of the cable sheath

Influence of Common Grounding Electrode on Yunnan-Guangdong DC Transmission Project and Guizhou-Guangdong Ⅱ DC Transmission Project

Load Modeling of CRH3 Electric Multiple Unit Traction Drive System