Abstract:A novel system based on the indirect oxy-combustion of coal in a liquid Sb anode solid oxide fuel cell (SOFC) has been used to produce electricity for over 48 h. Pulverized anthracite was fed to the liquidantimony-anode of the fuel cell, and a peak power density of 47 mW cm(-2) was reached at 1023 K and 35 mW cm(-2) at 973 K. The fuel cell was prepared using a porous stainless-steel tube as a support for an LSM cathode. antimony oxide (Sb2O3)/yittria stabilized zirconia (YSZ, Y(0.08)Z(0.92)O(1.96)) composite electrolyte (membrane), while liquid antimony acted as the anode. Liquid antimony/antimony oxide served as the intermediate medium for coal oxidation producing mainly carbon dioxide, which evolved as a separate gas stream. The fuel cell will facilitate carbon capture process, and simultaneously convert the chemical energy of coal directly to electricity. The experiment showed that while the fabricated electrolyte was porous, it became dense during the actual operation, preventing nitrogen leakage into the Sb/C side and producing reasonable open circuit voltage. Analysis of the experimental EIS data illustrates that the Ohmic resistance was the primary loss mechanism in the system. It further suggests approaches to improve the design. Continuous operation of this coal fueled oxy-combustion/fuel cell system achieved an overall efficiency of 28.2% despite of its tiny scale. Simple technologies can be employed to scale up this system at relatively low cost of fabrication and materials. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Liquid Antimony Anode Fluidization Within A Tubular Direct Carbon Fuel Cell

Introducing Anode Fluidization into a Tubular Liquid Antimony Anode Direct Carbon Fuel Cell

Direct Carbon Fuel Conversion in a Liquid Antimony Anode Solid Oxide Fuel Cell

Performance Characteristics of Liquid Antimony Anode Direct Carbon Fuel Cell

Liquid Antimony Anode Direct Carbon Fuel Cell Fueled with Mass-Produced De-Ash Coal

Numerical Simulation and Experimental Characterization of the Performance Evolution of A Liquid Antimony Anode Fuel Cell

Liquid Antimony Anode for Converting Sulfur-Containing Coal in Direct Carbon Fuel Cells

Performance Enhancement of Liquid Antimony Anode Fuel Cell by In-Situ Electrochemical Assisted Oxidation Process

Sulfur-Resistant Liquid Antimony Anode for Direct Carbon Fuel Cells

Oxy-combustion of Coal in Liquid-Antimony-anode Solid Oxide Fuel Cell System

Towards Feasible Temperature Management and Thermo-Mechanical Stability of Carbon-Assisted Solid Oxide Electrolysis Cell

Samaria-Doped Ceria Electrolyte Supported Direct Carbon Fuel Cell with Molten Antimony As the Anode

Plasma-spray Derived, Corrosion-Resistive Electrolyte for Liquid Antimony Anode Direct Carbon Fuel Cell

Cycling Characteristics of Tubular Liquid Antimony Anode Direct Carbon Fuel Cells Prepared by Atmospheric Plasma Spray

Development of Liquid Antimony Anode-Based Fuel Cells: Effects of Reaction-Induced Convection on Mass Transfer and Electrochemical Performance

Anode Fluidization of a Liquid Tin Anode SOFC Operated on Simulated Syngas

Fabrication and performance of atmospheric plasma sprayed solid oxide fuel cells with liquid antimony anodes

High Performance Tubular Solid Oxide Fuel Cells With Bscf Cathode

Effect of Grain Boundary Diffusion on Electrolyte Stability in Direct Carbon Fuel Cells with Antimony Anodes

Polarization Characteristics of Liquid Antimony Anode with Smooth Single-Crystal Solid Oxide Electrolyte

A Regenerative Coking and Sulfur Resistant Composite Anode with Cu Exsolution for Intermediate Temperature Solid Oxide Fuel Cells