Abstract:In the field of non-destructive evaluation (NDE) of solid metal materials, it has been a challenge to detect surface and internal defects simultaneously by using a single physical mechanism technique. Conventionally, different testing techniques, in which each one is particularly sensitive to a certain type of defect, are employed to gain full defect information. However, a separated testing method is always a time-consuming and laborious work. Here, we report a magnetoelectric-ultrasonic hybrid transducer and multimodal system for quantitative NDE of metal, which integrates a magnetoelectric composite wrapped with a coil for generating alternating current field and simultaneously measuring magnetic abnormal of surface defects (referred to as ME-ACFM) and a dual-piezoceramic ultrasonic transducer (DP-UT) for generating acoustic pulses and detecting the echo signal of internal defects, respectively. A bipulse signal with different pulse widths is used for excitation of the hybrid transducer, in which one is corresponded to the resonant frequencies of 5 MHz for DP-UT, and another to 122 kHz for ME-ACFM. The huge difference between two resonant frequencies is helpful for restraining signal interference each other. Experimental investigations show that when scanning the tested specimens (standard steel No.45 and aluminum plates), the surface and internal defects information can be obtained simultaneously almost without a dead zone. The surface defect resolutions of 0.1 mm width and 0.1 mm depth, and the inside defect resolution of 2 mm blind hole are obtained; the experimental errors for surface defect (crack) depth up to 5 mm are around 5 %; while experimental errors for ultrasonic depth measurement (with a blind zone of 1.25 mm) is less than 0.63 mm. The proposed hybrid transducer and multimodal system open up a new way for designing multi-physical mechanism based NDEs.

A Hybrid Nondestructive Testing Method of Pulsed Eddy Current Testing and Electromagnetic Acoustic Transducer Techniques for Simultaneous Surface and Volumetric Defects Inspection

Composite Defects Evaluation Using the Hybrid NDT Methods of PECT and EMAT

Complicated Defects Detection Based on Hybrid NDT Methods of PECT and EMAT

Mechanism Hybrid EMAT and Eddy Current Sensing Detection for Surface and Internal Defects NDT

A hybrid nondestructive testing method of pulsed eddy current testing and electromagnetic acoustic transducer techniques based on wavelet analysis

Physic perspective fusion of electromagnetic acoustic transducer and pulsed eddy current testing in non-destructive testing system

Multiphysics Structured Eddy Current and Thermography Defects Diagnostics System in Moving Mode.

Eddy Current Test/ultrasonic Testing Integrative Method for Detecting Sub-Surface Defects in Conductive Structures

A magnetoelectric-ultrasonic multimodal system for synchronous NDE of surface and internal defects in metal

Quantitative Sizing of Compound Location Defects Based on PECT-EMAT Hybrid Testing Methods

Physical coupling fusion sensing of MFL-EMAT for synchronous surface and internal defects inspection

A Composite Approach of Electromagnetic Acoustic Transducer and Eddy Current for Inner and Outer Corrosion Defects Detection

Defect Detection and Identification of Point-Focusing Shear-Horizontal EMAT for Plate Inspection

A New Method to Evaluate Surface Defects with an Electromagnetic Acoustic Transducer

Coupling Pulse Eddy Current Sensor for Deeper Defects NDT

Quantitative non-destructive testing of local wall thinning defect based on an efficient simulator of pulsed eddy current testing signals

DC-Biased Magnetization Based Eddy Current Thermography for Subsurface Defect Detection.

A Research on Composite Nondestructive Testing Sensor of Boiler Water Wall Tubes

Enhanced Nondestructive Testing Using Pulsed Eddy Current and Electromagnetic Ultrasonic Techniques

Composite Sensor of EMAT and ECT Using a Shareable Receiver Coil for Detecting Surface and Bottom Defects on the Steel Plate

Simulation and Experiment Study of Non-Destructive Testing Using Ema/Ec Dual Probe