Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Vanadium Supported on Graphitic Carbon Nitride As A Heterogeneous Catalyst for the Direct Oxidation of Benzene to Phenol

Amorphous Cr-doped G-C3n4 As an Efficient Catalyst for the Direct Hydroxylation of Benzene to Phenol

Enhanced Performance of Binary WO3/N-doped Carbon Composites for the Catalytic Oxidation of Benzyl Alcohol under Mild Conditions

Vanadium-Containing Mesoporous Carbon and Mesoporous Carbon Nanoparticles As Catalysts for Benzene Hydroxylation Reaction

Amorphous Vanadium Oxide Supported on Activated Carbon Prepared by Dielectric Barrier Discharge as an Efficient and Stable Catalyst for Hydroxylation of Benzene to Phenol

Cerium Promoted V-g-C3N4 As Highly Efficient Heterogeneous Catalysts for the Direct Benzene Hydroxylation

In Situ Fabrication of Highly Active Γ-Mno2/smmno3 Catalyst for Deep Catalytic Oxidation of Gaseous Benzene, Ethylbenzene, Toluene, and O-Xylene.

Direct Hydroxylation of Benzene to Phenol Using H2o2 As an Oxidant over Vanadium-Containing Nitrogen Doped Mesoporous Carbon Catalysts

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

Direct Hydroxylation of Benzene to Phenol over Metal Oxide Supported Graphene Oxide Catalysts

Catalytic Oxidation of 1,2-Dcbz over V2O5/TiO2-CNTs: Effect of CNT Diameter and Surface Functional Groups.

Vanadium oxide supported on mesoporous MCM-41 as new catalysts for dehydrogenation of ethylbenzene with CO2

VO<sub>x</sub>-MoO<sub>y</sub> single molecular layer modified graphic carbon nitride polymer for enhanced selective styrene oxidation

A High-Performance Catalyst Support for Methanol Oxidation with Graphene and Vanadium Carbonitride.

Supported Vanadia Catalysts for Dehydrogenation of Ethylbenzene with CO 2

Synergistic Combination of Graphitic C3N4 and Polyoxometalate-Based Phase-Transfer Catalyst for Highly Efficient Reductant-Free Aerobic Hydroxylation of Benzene

Oxygen-Enriched Biomass-Activated Carbon Supported Platinum Nanoparticles as an Efficient and Durable Catalyst for Oxidation in Benzene

Structure–Activity Relationship for the Catalytic Hydrogenation of Nitrobenzene by Single Platinum Atoms Supported on Nitrogen-Doped Carbon

Cu-dopedmesoporous VO_x-TiO_2 incatalytic hydroxylation of benzene to phenol

High Catalytic Activity and Selectivity for Hydroxylation of Benzene to Phenol over Multi-Walled Carbon Nanotubes Supported Fe3O4 Catalyst

Vanadium Oxide Supported on Mesoporous SBA-15 As Highly Selective Catalysts in the Oxidative Dehydrogenation of Propane