Abstract:Low force ripples from permanent magnet linear motors (PMLMs) are typically essential requirements in a wide range of demanding control applications with high motion quality. Apart from the sources present in rotary PM machines, phase unbalance due to the end effect is another major contributor of the thrust force ripples in the PMLMs. In this paper, the phase unbalance and induced force ripples are investigated in the case of a planar PMLM typically equipped with single-layer concentrated windings and quasi-Halbach magnets. It demonstrates that although the PMLM is quite carefully deigned to minimize the end effect, the phase unbalance still exists, including both the amplitude and phase position unbalances. And the phase unbalances give rise to even order force ripple harmonics, in which the 2 nd -order force ripple is particularly significant. In order to compensate the end effect and the unbalance between the three phases, a novel PMLM topology is presented, in which the width of the two end teeth (instead of the edge teeth) is adjusted to reduce the force ripple. And the impact of the end teeth width on the ripple force magnitude is further revealed. It is shown that by proper design of the end teeth width, the 2 nd -order force ripple of the PMLM can be minimized to quite a low extent. In comparison with the original design, the 2 nd -order force ripple factor of the novel topology has been suppressed from 0.4% to less than 0.03% in the case study. Such a technique has provided a new way of force ripple minimization, and is applicable to other types of linear motors or actuators with appropriate changes.

Minimization of Cogging Force in Fractional-Slot Permanent Magnet Linear Motors with Double-Layer Concentrated Windings

Detent Force Fast Optimization Method of Modular Permanent-Magnet Linear Synchronous Motors

A Cogging Torque Reduction Method for Surface Mounted Permanent Magnet Motor

Analysis and Reduction of Detent Force in Permanent Magnet Linear Synchronous Motor

Solution of Permanent Magnet Synchronous Motors with Partition between Poles Halbach Magnet

Assessment of cogging-force-reduction techniques applied to fractional-slot linear permanent magnet motors equipped with non-overlapping windings

Detent-Force Analysis and Reduction of Modular Permanent-Magnet Linear Synchronous Motors with Non-overlapping Windings

Detent Force Analysis and Optimization of Permanent Magnet Linear Synchronous Motor

Cogging force and its estimation using a neural network based on 2D field model of PMLSM

Cogging force estimator based on BP neural network of PMLSM

Comparative Investigation Of Single-Sided And Double-Sided Permanent Magnet Linear Motor

Slot/Pole Number Combination Research of-PM Linear Motors With Fractional Slots per Pole

Study of magnet shifting for reduction of cogging torque in permanent magnet motors

Force Ripple Minimization Design for Consequent Pole Permanent Magnet Linear Synchronous Motor

Thrust Ripple Optimization and Experiment for a Permanent Magnet Linear Synchronous Motor

Design and Optimization of a Novel Permanent Magnet Linear Motor with the Same Number of Poles and Slots

Cogging Force Analysis Of Tubular Linear Permanent Magnet Motors

Design Consideration of Fractional Slot Concentrated Winding Interior Permanent Magnet Synchronous Motor for EV and HEV Applications

Optimal Design of Tubular Transverse Flux Motors with Low Cogging Forces for Direct Drive Applications

Optimization and Performance Investigation of High Precision Permanent Magnet Linear Motor

Analysis and Suppression of Phase Unbalance Induced Force Ripples in Permanent Magnet Linear Motors