Abstract:When hot and cold fluids are mixed at pipeline tees, temperature fluctuations are generated and can lead to thermal fatigue damage in the piping materials. At the University of Stuttgart in Germany, experimental investigations have been performed for understanding the flow mixing mechanism causing thermal fatigue. It was found that the inlet flow rate is one of the decisive factors on the mixing behaviors at a horizontal T-junction. In this study, the influence of the inlet flow rate on the flow mixing behaviors at the vertical T-junction is investigated using the large-eddy simulation (LES) method. The simulations are validated with the previous experiments and provide a good overview of the mixing flow. The LES method shows the advantage of illustrating the collision of two flow streams at the T-junction, which leads to different behaviors of the mixing flow. Generally, the temperature fluctuation in the mixing flow as well as the stability of thermal stratification decreases along the flow direction due to the dissipation of the turbulent kinetic energy in the mixing flow. The decrease in the main flow rate shows the impact of the increase in thermal stratification stability and the reverse flow distance. The decrease in the branch flow leads to a slight increase of the thermal stratification stability downstream of the T-junction and significant turbulent penetration in the branch pipe. The maximum temperature fluctuation at the pipeline inner surface is located at the joint position of the pipelines with a value higher than 30 K. Moreover, the flow collision at the T-junction leads to significant secondary flow in the mixing region, which can be influenced by the variations in the inlet flow rate. In particular, the secondary flow due to cold fluid presents a phenomenon of counter-rotating vortex pair (CRVP), and generates a temperature fluctuation with a frequency of approximately 1.1 Hz, which is recorded by the monitor points at both horizontal sides of the pipeline. In comparison with the previous work at the horizontal T-junction, the complete flow collision at the vertical T-junction is the reason for the totally different mixing phenomenon.

Experimentally Investigating the Thermal Mixing and Thermal Stripping Characteristics in A T-Junction

Investigating Effects of Injection Angles and Velocity Ratios on Thermal-Hydraulic Behavior and Thermal Striping in a T-junction

Investigating Thermal Mixing and Reverse Flow Characteristics in A T-Junction by Way of Experiments

Experimental Observations of Thermal Mixing Characteristics in T-Junction Piping

Investigating Thermal Mixing and Reverse Flow Characteristics in a T-junction Using CFD Methodology

Numerical and Experimental Investigation of Mixing Characteristics in the Constructal Tree-Shaped Microchannel

Numerical investigation of thermal-mixing characteristics at vertically oriented T-junction pipelines

Experimental Study of Solute Mixing at Double-Tee Junctions in Water Distribution Systems

Two-phase Flow Oscillation and Distribution in Parallel Channels During R1233zd(E) Subcooled Flow Boiling: A Numerical Study

Saturated Flow Boiling Heat Transfer of R1233zd(E) in Parallel Mini-Channels: Experimental Study and Flow-Pattern-based Prediction

Experimental Study of Turbulent Mixing in A Tee Mixer Using Piv and Plif

Experimental study on the flow mixing in T-junctions with an impeller

Analysis of Fluid Flow Characteristic with Different Temperature and Different Methods in T-junction Pipe

Heat transfer process for penetration flow into a branch pipe causing thermal fatigue at a T-junction

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

Mechanism and experimental study of thermal mixing of fluid with different temperature

Experimentally Investigating Phase Separation and Pressure Drop As Bubbly Flow in a Vertical Branching T-junction

Experimental Study on the Thermo-Hydrodynamic Characteristics of a Nitrogen Pulsating Heat Pipe

Turbulent flow in an I–L junction: Impacts of the pipe diameter ratio

Large Eddy Simulation of Hot and Cold Fluids Mixing in A T-Junction for Predicting Thermal Fluctuations

Effects on the Mixing Process of a Coiled Tube after a T-junction:Simulation and Correlation