Abstract:When hot and cold fluids are mixed at pipeline tees, temperature fluctuations are generated and can lead to thermal fatigue damage in the piping materials. At the University of Stuttgart in Germany, experimental investigations have been performed for understanding the flow mixing mechanism causing thermal fatigue. It was found that the inlet flow rate is one of the decisive factors on the mixing behaviors at a horizontal T-junction. In this study, the influence of the inlet flow rate on the flow mixing behaviors at the vertical T-junction is investigated using the large-eddy simulation (LES) method. The simulations are validated with the previous experiments and provide a good overview of the mixing flow. The LES method shows the advantage of illustrating the collision of two flow streams at the T-junction, which leads to different behaviors of the mixing flow. Generally, the temperature fluctuation in the mixing flow as well as the stability of thermal stratification decreases along the flow direction due to the dissipation of the turbulent kinetic energy in the mixing flow. The decrease in the main flow rate shows the impact of the increase in thermal stratification stability and the reverse flow distance. The decrease in the branch flow leads to a slight increase of the thermal stratification stability downstream of the T-junction and significant turbulent penetration in the branch pipe. The maximum temperature fluctuation at the pipeline inner surface is located at the joint position of the pipelines with a value higher than 30 K. Moreover, the flow collision at the T-junction leads to significant secondary flow in the mixing region, which can be influenced by the variations in the inlet flow rate. In particular, the secondary flow due to cold fluid presents a phenomenon of counter-rotating vortex pair (CRVP), and generates a temperature fluctuation with a frequency of approximately 1.1 Hz, which is recorded by the monitor points at both horizontal sides of the pipeline. In comparison with the previous work at the horizontal T-junction, the complete flow collision at the vertical T-junction is the reason for the totally different mixing phenomenon.

Investigating Effects of Injection Angles and Velocity Ratios on Thermal-Hydraulic Behavior and Thermal Striping in a T-junction

Experimentally Investigating the Thermal Mixing and Thermal Stripping Characteristics in A T-Junction

Effect of Taper Angle on the Performance of Jet Pumps for a Loop-Structured Thermoacoustic Engine

Investigating Thermal Mixing and Reverse Flow Characteristics in A T-Junction by Way of Experiments

The Effect of Swirling Injector Geometry on the Flow Dynamics of Precessing Vortex Core

Simultaneous Measurements of Velocity and Concentration Fields in an Inclined Jet in Crossflow

Investigating Thermal Mixing and Reverse Flow Characteristics in a T-junction Using CFD Methodology

Experimental Observations of Thermal Mixing Characteristics in T-Junction Piping

Numerical investigation of thermal-mixing characteristics at vertically oriented T-junction pipelines

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

An Investigation of the Temperature Distributions Inside A Spool Valve Owing to A Viscous Heating Effect

Experimentally investigating effects of gap size and injection flowrate on heat transfer and boiling characteristics for the downward facing wall heating

Regulation of Gas-Liquid Stratified Flow Boiling Dynamic Instabilities in Horizontal Tube: Effects of Heat Load Distribution and Wall Thermal Capacity

Experimental study on the flow mixing in T-junctions with an impeller

Turbulent flow in an I–L junction: Impacts of the pipe diameter ratio

Analysis of vortex structure, temperature distribution, and near-wall flow development for an inclined jet interacting with crossflow of different boundary layer conditions

Cfd Investigating the Effects of Different Mixing Vane Designs on the Localized Thermal-Hydraulic Characteristics in the Rod Bundles with Grid Spacer

Numerical Investigation of the Flow and Infrared Radiation Characteristics of Nozzles with Transverse Jets of Different Shapes

Heat transfer process for penetration flow into a branch pipe causing thermal fatigue at a T-junction

Effects on the Mixing Process of a Coiled Tube after a T-junction:Simulation and Correlation

Experimental investigation on the effects of transverse injection distribution scheme on dual flame dynamics subjected to flow disturbances