Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

A Ku-Band Cmos Lna With Transformer Feedforward Gm-Boosting Technique

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A Gm-boosted and current peaking wideband merged LNA and mixer

Design of a Broadband Ka-band MMIC LNA Using Deep Negative Feedback Loop.

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Q-band CMOS LNA Exploiting Transformer Feedback and Noise-Cancelling

A Ku-Band 3.3-V LNA with Multicoupled Q-Enhancement Transformer and Current-Reuse Techniques in 65-Nm CMOS

A Q-band CMOS LNA with noise cancellation

A 37-to-41.8 GHz Double-Gm-Boosting LNA with 2.9-Db NFmin Using Quadruple-Coupling Transformer for Phased-Array Transceivers.

A High Gain Cmos Lna For Ka-Band Communication System

A 10‐mw 3.9‐db NF Transformer‐based V‐band Low‐noise Amplifier in 65‐nm CMOS

A 28-/39-ghz Dual-Band CMOS LNA with Shunt-Series Transformer Feedback

A 52–73-GHz LNA With Tri-Coupled Transformer for G m Boosting and Enhanced Noise Canceling

A 54.4–90 GHz Low-Noise Amplifier in 65-nm CMOS

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

A V-Band Compact LNA With G<inf>m</inf>-Boosting and Noise-Cancelling Technique

A W-Band Low Noise Amplifier with High Gain and Low Noise Figure in 65-Nm CMOS

A 22–33-GHz $G_{m}$-Boosting Low-Power Noise-Canceling LNA in 40-nm CMOS Process

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

Design of Ka band Low Noise Amplifier Based on 65nm CMOS Technology