Abstract:Two-dimensional transition metal dichalcogenides (TMDCs) have natural advantages in overcoming the short-channel effect in field-effect transistors (FETs) and in fabricating three-dimensional FETs, which benefit in increasing device density. However, so far, most reported works related to MoS2 FETs with a sub-100 nm channel employ mechanically exfoliated materials and all of the works involve electron beam lithography (EBL), which may limit their application in fabricating wafer-scale device arrays as demanded in integrated circuits (ICs). In this work, MoS2 FET arrays with a side-wall source and drain electrodes vertically distributed are designed and fabricated. The channel length of the as-fabricated FET is basically determined by the thickness of an insulating layer between the source and drain electrodes. The vertically distributed source and drain electrodes enable to reduce the electrode-occupied area and increase in the device density. The as-fabricated vertical FETs exhibit on/off ratios comparable to those of mechanically exfoliated MoS2 FETs with a nanoscale channel length under identical VDS. In addition, the as-fabricated FETs can work at a VDS as low as 10 mV with a desirable on/off ratio (1.9 × 107), which benefits in developing low-power devices. Moreover, the fabrication process is free from EBL and can be applied to wafer-scale device arrays. The statistical results show that the fabricated FET arrays have a device yield of 87.5% and an average on/off ratio of about 1.7 × 106 at a VDS of 10 mV, with the lowest and highest ones to be about 1.3 × 104 and 1.9 × 107, respectively, demonstrating the good reliability of our fabrication process. Our work promises a bright future for TMDCs in realizing high-density and low-power nanoelectronic devices in ICs.

Multi-VT Design of Vertical Channel Nanowire FET for Sub-10Nm Technology Node

Vertical nanowire/nanosheet FETs with a horizontal channel for threshold voltage modulation

Source/Drain Architecture Design of Vertical Channel Nanowire Fet for Sub-10nm Node

Deep Insight into Channel Engineering of Sub-3 Nm-Node P-Type Nanosheet Transistors with a Quantum Transport Model

3D Logic Cells Design and Results Based on Vertical NWFET Technology Including Tied Compact Model

Investigation of Novel Hybrid Channel Complementary FET Scaling Beyond 3-nm Node From Device to Circuit

Vertical C-Shaped-Channel Nanosheet FETs Featured With Precise Control of Both Channel-Thickness and Gate-Length

Enhanced Device Performance with Vertical SiC Gate-All-Around Nanowire Power MOSFETs

Two-Dimensional Vertical Transistor with One-Dimensional van der Waals Contact

Self-aligned Multi-Channel Silicon Nanowire Field-Effect Transistors

Carbon-Nanotube-Confined Vertical Heterostructures with Asymmetric Contacts

Design of Complementary GAA-NW Tunneling-Fets of Axial Si-Ge Heterostructure

Analysis and Design of Novel Doping Free Silicon Nanotube TFET with High-density Meshing Using ML for Sub Nanometre Technology Nodes

The Investigation of Negative Capacitance Vertical Nanowire FETs Based on SPICE Model at Device-Circuit Level

First Demonstration of Novel Vertical Gate-All-Around Field-Effect-Transistors Featured by Self-Aligned and Replaced High-κ Metal Gates

Simulation of Novel Nano Low-Dimensional FETs at the Scaling Limit

Process optimization for random threshold voltage variation reduction in nanoscale MOSFET by 3D simulation

Design and Performance Optimization of Dopingless Vertical Nanowire TFET Using Gate Stacking Technique

The synergistic effect of vertical structural parameters of vertical-type two-dimensional hole gas diamond MOSFETs on improving the overall performance of devices based on TCAD simulation

Nanoscale Channel Length MoS2 Vertical Field-Effect Transistor Arrays with Side-Wall Source/Drain Electrodes

Modeling And Simulation Of Carbon Nanotube-Semiconductor Heterojunction Vertical Field Effect Transistors