Abstract:Despite the wealth of literature on the friction and wear behaviour of ceramics, their wear mechanisms are far from well understood. The need to develop a precise understanding of the wear mechanisms is imperative for the development of better wear-resistant ceramics. Particularly in alumina ceramics, grain coarsening has been found to improve the crack growth resistance characteristics. However, if the same would be beneficial for wear resistant applications has not been systematically investigated. To evaluate if there exists a strong grain size effect on abrasive wear mechanisms in ceramics, a series of tests were conducted under severe sliding contact conditions in an alumina ceramic. Unlubricated sliding wear tests were performed on alumina of three different grain sizes, 0.7, 5 and 25 μm, using a blunt conical diamond indenter of about 100-μm tip radius as the slider at room temperature under normal loads of 8–40 N and sliding distances up to 120 mm. The abrasive wear behaviour was characterised by measuring the wear volume and wear rate as a function of normal load and sliding distance. In addition, the friction behaviour was also studied simultaneously as a function of these two variables. The wear damage mechanisms were examined using both optical and electron microscopy as well as energy dispersive X-ray spectroscopy. For a given grain size and sliding distance, the width and depth of the worn track (hence wear volume) and the frictional force all increased with normal load. These observations were more markedly displayed in the coarse-grained than in the fine-grained alumina. In the 0.7-μm fine-grained alumina, the wear process appeared to be mainly controlled by plastic deformation especially at low loads (e.g. < 10 N). At higher loads, however, both plastic deformation and grain boundary fracture processes seemed to be involved. In the 5-μm and 25-μm coarse-grained aluminas, the predominant material removal process was controlled by both intergranular and transgranular fractures.

Effect of Grain Size on the Adhesive and Ploughing Friction Behaviours of Polycrystalline Metals in Forming Process

An investigation on the friction in a micro sheet metal roll forming processes considering adhesion and ploughing

Investigation on the Friction Mechanism and Its Relation to the Force Chains During Powder Compaction

Coupling effect of plastic deformation and surface roughness on friction behaviors of rough line contact for ground metal surfaces

Relation Between Force Chain Quantitative Characteristics and Side Wall Friction Behaviour During Ferrous Powder Compaction

Correlation Mechanism Between Force Chains and Friction Mechanism During Powder Compaction

Atomistic investigation of the mechanical and tribological responses of the ferrite-cementite interface with a Bagaryatskii orientation

Investigation of Interfacial Friction and Inverse Flowing Behavior under the Adhesive State

Effects of Interface Friction States on Plastic Deformation in Metal Surface and Bulk

Effect of grain size on subsurface characterization of pure iron subjected to orthogonal cutting

Study on micro-plastic behavior and tribological characteristics of granular materials in friction process

Grain size effect on abrasive wear mechanisms in alumina ceramics

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Effects of indentation depth and grain size on scratching behavior of nanograin FCC Fe polycrystalline substrate

Understanding adhesive sliding nanocontact mechanics in an exponentially graded coating-substrate structure

Effect of Grain Size on the Tribological Behavior of CoCrFeMnNi High Entropy Alloy

Experimental and modelling study of interaction between friction and galling under contact load change conditions

Effect and performance analysis of different surface treatments on polymer-metal friction pairs

Effect of the sliding-rolling ratio on the force chain properties of granular flow lubrication interfaces

Molecular Dynamics Study on Friction Due to Ploughing and Adhesion in Nanometric Scratching Process

Effect of Young’s Modulus and Surface Roughness on the Inter-Particle Friction of Granular Materials