Abstract:Diesel engine emissions for on-road, stationary and marine applications are regulated in the United States via standards set by the Environmental Protection Agency (EPA). A major component of diesel exhaust that is difficult to reduce is nitrogen oxides (NOx). Selective catalytic reduction (SCR) has been in use for many years for stationary applications, including external combustion boilers, and is promising for NOx abatement as a retrofit for mobile applications where diesel compression ignition engines are used. The research presented in this paper is the first phase of a program focused on the reduction of NOx by use of a stand-alone urea injection system, applicable to marine diesel engines typical of work boats (e.g., tugs). Most current urea SCR systems communicate with engine controls to predict NOx emissions based on signals such as torque and engine speed, however many marine engines in use still employ mechanical injection technology and lack electronic communication abilities. The system developed and discussed in this paper controls NOx emissions independentof engine operating parameters and measures NOx and exhaust flow using the following exhaust sensor inputs: absolute pressure, differential pressure, temperature, and NOx concentration. These sensor inputs were integrated into an independent controller and open loop architecture to estimate the necessary amount of urea needed, and the controller uses pulse width modulation (PWM) to power an automotive fuel injector for airless urea delivery. The system was tested in a transient test cell on a 350 hp engine certified at 4 g/bhp-hr of NOx, with a goal of reducing the engine out NOx levels by 50%. NOx reduction capabilities of 41-67% were shown on the non road transient cycle (NRTC) and ICOMIA E5 steady state cycles with system optimization during testing to minimize the dilute ammonia slip to cycle averages of 5-7 ppm. The goal of 50% reduction of NOx can be achieved dependent upon cycle. Further research with control optimization, urea distribution and possible use of oxidation catalysts is recommended to improve the NOx reduction capabilities while minimizing ammonia slip.

Integrated Study of Inland-Vessel Diesel Engine Two-Cell SCR Systems with Dynamic References

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

Fluid Mixing Optimization Strategy of Catalytic Reactor for Marine SCR System

Ammonia coverage ratio control of a novel two-cell SCR-DeNOX system configuration based on IA-ISMC

Model Predictive Control Case Study: Selective Catalytic Reduction (scr) System in Coal-Fired Power Plant

Robust, Model-Based Urea Dosing Control for SCR Aftertreatment Systems using a Cross-Sensitive Tailpipe NOx Sensor

A fuzzy logic urea dosage controller design for two-cell selective catalytic reduction systems

Nonlinear Model Predictive Control of Integrated Diesel Engine and Selective Catalytic Reduction System for Simultaneous Fuel Economy Improvement and Emissions Reduction

Diesel Engine SCR Control: Current Development and Future Challenges

Design and testing of an independently controlled urea SCR retrofit system for the reduction of NOx emissions from marine diesels

Closed-Loop Control Strategy and State Estimator for Diesel Engine SCR After-Treatment System

Optimization of the ammonia coverage ratio references in diesel engine two-can selective catalytic reduction systems via nonlinear model predictive control

Model-based urea injection control strategy and ammonia storage estimation for diesel engine SCR system

Model-based NH3 Adaptation Method for SCR Control

Review on Selective Catalytic Reduction Technology of Diesel Engines

Experimental demonstration of NOx reduction and ammonia slip for diesel engine SCR system

Development and verification of model predictive control strategy for selective catalytic reduction with rapid prototyping

SCR (selective catalytic reduction) system for small and medium-sized ships

Model Predictive Control: A Unified Approach for Urea-Based SCR Systems

Optimization of Automatic Control System for $\text{no}_{\mathrm{x}}$ Emission Reduction in Smart Marine Diesel Engine

Black Box SCR Modeling and Control for Small CI Engines