Abstract:Bamboo, a biomaterial with a unique gradient structure, possesses exceptional mechanical properties. The gradient structure impacts the mechanical properties of bamboo in the longitudinal (L), radial (R) and tangential (T) directions. To investigate the elasticity associated with gradient structure, we derived the orthotropic elastic constants: Young’s modulus (E), Poisson’s ratio (ν) and shear modulus (G) at different radial positions (outer, central and inner) through micro-tensile testing and the digital image correlation (DIC) technique. Our results revealed that the Young’s modulus of bamboo exhibited a characteristic orthotropic behavior irrespective of radial position. The ratio of E in the L, T and R directions (E L:E T:E R) was 6.05:1.08:1, 5.12:1.17:1 and 8.02:1.58:1, respectively at the outer, central and inner positions. With increasing fiber fraction, ν (except νRT) demonstrated an upward trend. Under main axis tension, fiber pull-out and brittle fracture were the main failure modes, whereas off-axis tension exposed the vulnerable interface between fibers and parenchyma cells. The enhancement effect of the gradient structure in the L and T directions was more prominent, resulting in a consistent deformation pattern from the inner to outer positions. However, strain localization was found when tensioning through the R direction. Leveraging the derived orthotropic elastic constants, we visualized the three-dimensional elastic behavior of bamboo by body deformation. Bamboo at the outer position exhibited quasi-isotropic behavior in the RT plane due to the high fiber fraction. This study provides critical experimental evidence for the orthotropic behavior of bamboo at different radial positions and valuable data for mechanical modeling and practical applications involving bamboo.

Orthotropic Elastic-Constants For Eastern Hardwood Species

Elastic-Constants for Hardwoods Measured from Plate and Tension Tests

High-strain Rate Compressive Behavior of Douglas Fir and Glubam

Delayed Elastic Strain and Set-Recovery Evaluation in High-Pressure Densified Hybrid Poplar Wood – New Assessment Considerations

Full elastic properties characterization of wood by ultrasound using a single sample

Temperature and time dependence of orthotropic viscoelastic properties of moist wood determined in tensile mode

Measuring elastic constants of wood through static bending using a strain gauge

Moisture and short-term time-dependent behavior of Norway spruce clear wood under compression perpendicular to the grain and rolling shear

Comprehensive creep compliance characterization of orthotropic materials using a cost-effective automated system

Comparison and parametric study of characteristics of eleven types of anisotropic woods based on the behaviour of Lamb wave propagation

Compressive Mechanical Properties of Larch Wood in Different Grain Orientations

Rheological behavior of wood in stress relaxation under compression

Viscoelastic properties of green wood across the grain measured by harmonic tests in the range of 0\degree C to 95\degree C. Hardwood vs. softwood and normal wood vs. reaction wood

Orthotropic hygric and mechanical material properties of oak wood

Rheological Model for Wood

Estimation of the in-situ elastic constants of wood pulp fibers in freely dried paper via AFM experiments

Standardized Compliance Matrices for General Anisotropic Materials and A Simple Measure of Anisotropy Degree Based on Shear-Extension Coupling Coefficient

Evaluation of orthotropic elasticity of gradient-structured bamboo by microtensile testing combined with digital image correlation technique

Elasto-plastic material model of green beech wood

Intra-Ring Wood Density and Dynamic Modulus of Elasticity Profiles for Black Spruce and Jack Pine from X-ray Densitometry and Ultrasonic Wave Velocity Measurement

Tension Performance of Metal-Plate Connected Joints of Chinese Larch Dimension Lumber