Abstract:A novel energy-saving and area-efficient tri-level switching scheme is proposed for successive approximation register analog-to-digital converters (SAR ADCs). Different from most published tri-level switching schemes, a new third reference voltage Vaq which equals to 1/4 Vref is applied to the proposed scheme. And benefiting from Vaq, the proposed scheme achieves 87.5% capacitor area reduction over the conventional scheme. Due to the capacitor-splitting structure and top-plate sampling, the switching energy is negative during the first three switching cycles, which means the capacitor arrays return energy back to the reference voltages and results in significant energy saving. For a 10-bit SAR ADC, the average switching energy of proposed scheme is only 5.3 \(CV_{{{\text{ref}}}}^{2}\), which realizes 99.61% energy saving compared with the conventional scheme. Moreover, the proposed scheme is of low control logic complexity since single-side switching is applied during the remaining switching cycles. Therefore, the proposed scheme achieves a good trade-off among energy saving, area efficiency and logic complexity. For a 10-bit SAR ADC, the simulated differential nonlinearity (DNL) and integral nonlinearity (INL) with 1% capacitor mismatch are 0.322 LSB and 0.321 LSB, respectively. Considering 0.3% reference voltage mismatch, the mean values of effective number of bits (ENOB), signal-to-noise-and-distortion ratio (SNDR) and spurious-free-dynamic-range (SFDR) are 9.77 bit, 60.57 dB and 75.43 dB, respectively, through 500 Monte Carlo simulations. To verify the feasibility of circuit implementation, transistor level simulation of a 0.6-V 10-bit 200-KS/s SAR ADC in 40-nm CMOS technology is performed. The ENOB, SNDR and SFDR of SAR ADC with 98.83-kHz Nyquist rate input are 9.66 bit, 59.90 dB and 71.98 dB, respectively.

Non-Ideal Effects of Mos Capacitor in A Switched Capacitor Waveform Recorder Asic

A New Kind of Switched Capacitor Array

A 2.1/5.2-NEF/PEF Capacitively Coupled Instrumentation Amplifier with Fast - Settling for Biosensor

Modeling of a 200 KHz Bandwidth Low-pass Switch-capacitor Sigma-delta DAC with a Raised Spur-free Modulator

A 100 Ms/S 9 Bit 0.43 Mw Sar Adc with Custom Capacitor Array

Novel Calibration Method for Switched Capacitor Arrays Enables Time Measurements With Sub-Picosecond Resolution

An 11-Bit 22-Ms/s 0.6 Mw Sar Adc with Parasitic Capacitance Compensation

A 960 Μw 10-Bit 70-Ms/s SAR ADC with an Energy-Efficient Capacitor-Switching Scheme

A Design Method of Capacitor Arrays for High-Resolution SAR ADCs

Large Bandwidth RGC Transimpedance Preamplifier Design in SCA

Energy-Efficient and Area-Saving Asymmetric Capacitor Switching Scheme for SAR ADCs.

A 12b 200KS/s SAR ADC with novel capacitor switching procedure and digital background calibration

A Capacitive Dac with Custom 3-D 1-Ff Mom Unit Capacitors Optimized for Fast-Settling Routing in High Speed Sar Adcs

Casca: A Readout Asic For A Tpc Based X-Ray Polarimeter

A split-capacitor vcm-based capacitor-switching scheme for low-power SAR ADCs

A successive approximation ADC with resistor-capacitor hybrid structure

100ms/S 9-Bit 0.43mw Sar Adc With Custom Capacitor Array

A 6bit 550Ms/s small area low power successive approximation ADC

A Mosfet-Only Delta-Sigma Modulator for Implantable Neural Signal Sensors

A Power-Efficient Reference Buffer with Wide Swing for Switched-Capacitor ADC

A Low-Energy and Area-Efficient Vaq-Based Switching Scheme with Capacitor-Splitting Structure for SAR ADCs