Abstract:Highlights • Performance of the MIMO systems declines when geometric and mechanical parameters are inaccurate. • Traditional calibration of these parameters by means of measurement is complicated. • Optimizing the decoupling matrix directly with measurement data. • A calibrated static decoupling matrix with consistency can be obtained using instrument variable. Decoupling control is a commonly employed technique for achieving high precision in multiple-input multiple-output (MIMO) motion control systems. A static decoupling matrix, which can be determined using geometric construction, is widely used due to its practicality and simplicity. However, inaccurate geometric parameters will lead to a coarse decoupling matrix, and result in interactions among the system axes and performance deterioration. To tackle this challenge, various attempts have been undertaken to calibrate the decoupling matrix. Data-driven on-line approaches have gained considerable attention for their ability to calibrate the decoupling matrix without interrupting the normal operation of the system. This paper presents a data-driven approach to calibrate the decoupling matrix for MIMO and linear time invariant (LTI) systems. Through some reasonable assumptions, a calibrated static decoupling matrix can be derived to improve the performance of the system. Moreover, considering the inevitable presence of measurement noise, the consistency of the proposed method has been analyzed. As a result, the instrument variable is introduced in the improved method to eliminate the impact of the measurement noise. Finally, the effectiveness and practicality of the proposed method are demonstrated through both numerical simulations and experiments carried out on an ultraprecision wafer stage.

Optimization of Current Distribution Coefficients to Decouple the 6-DOF Fine Stage of Lithographic Equipment

A MIMO Decoupling Algorithm for Rapid Heating Systems of Wafers

Iterative control decoupling tuning for precision MIMO motion systems: A matrix update method

Decoupled Adaptive Terminal Sliding Mode Control Strategy for a 6-DOF Electro-Hydraulic Suspension Test Rig with RBF Coupling Force Compensator

Iterative Tuning of Decoupling Controller for 3-DOF Precision Motion Stage

Decoupled Control for Planar Motor Based on Self-Adaptive Correction for Current Distribution Coefficient

Coupled Dynamic Modeling and Analysis of Ultra-precision 6-DOF Fine Stage

A Data-Driven Iterative Decoupling Feedforward Control Strategy with Application to an Ultraprecision Motion Stage

Data-Based Iterative Dynamic Decoupling Control for Precision MIMO Motion Systems.

Decoupling control for spatial six-degree-of-freedom electro-hydraulic parallel robot

Decoupling Compensation for Damping Improvement of the Electrohydraulic Control System with Multiple Actuators

Structural Optimization of the Cable-Pipe Assembly for a Lithography Stage Based on the Finite Element Method

Optimal Actuator Placement and Active Vibration Control of Over-Actuated Motion System in the Wafer Stage

Dynamic Decoupling Control Strategy for 6-DOF Motion Simulator Based on Singular Value Decomposition.

Decoupling and Levitation Control of A Six-Degree-Of-Freedom Magnetically Levitated Stage with Moving Coils Based on Commutation of Coil Array

Planar 3-DOF Magnetic Micro-motion Stage and Its Decoupling Control

Simultaneous Decoupling Control of Translation and Rotation for a 6-DOF Vibration Isolator Based on the Stewart Platform

Decoupling control for a multi-DOF pneumatic manipulator subject to imbalanced torques

Design and control of a decoupled two degree of freedom translational parallel micro-positioning stage

Data-driven calibration of decoupling matrix for MIMO precision motion stages

Research of Plane Wafer Stage's 6-DOF Ultra-preci-sion Displacement Measurement