Abstract:N‐type Mg3Sb2‐based material is recognized as a promising thermoelectric material. Ag is revealed as an effective dopant for the Mg3.2Sb1.5Bi0.49Te0.01 system with a different effect from Cu. A peak ZT of 1.64 at 673 K is achieved. Moreover, a 2‐pair module fabricated with MgAgSb as p‐type material, results in a high ηmax of ≈7.9% at relatively low ΔT of 277 K. The n‐type Mg3(Sb, Bi)2 compounds show great potential for wasted heat energy harvesting due to their promising thermoelectric properties. This work discovers that doping transition element Ag into the n‐type Mg3(Sb, Bi)2 can effectively optimize the power factor and suppress the lattice thermal conductivity simultaneously. Interestingly, the Ag doping has different effects compared to the isoelectronic and same group element Cu addition studied previously. A high power factor of 19.6 μW cm−1 K−2 is obtained at 673 K owing to the increased electrical conductivity. At the same time, the lattice thermal conductivity is reduced to ≈0.5 W m−1 K−1 because of enhanced phonon scattering induced by Ag atoms. These improvements lead to a peak figure of merit (ZT) of 1.64 at 673 K as well as a high average ZT of 1.27 is obtained from 323 K to 673 K. Furthermore, a thermoelectric single leg with a competitive conversion efficiency of ≈11% under a hot‐side temperature of 673 K is fabricated successfully. In addition, a 2‐pair module composed of n‐type Mg3(Sb, Bi)2 alloy and p‐type MgAgSb‐based compound demonstrates the high conversion efficiency of ≈7.9% at a temperature difference of 277 K, which will significantly upgrade the sustainable energy recycling technology.

Improving Thermoelectric Performance of P-Type Ag-doped Mg2Si0.4Sn0.6 Prepared by Unique Melt Spinning Method

Enhanced thermoelectric performance of Sb-doped Mg2Si0.4Sn0.6 via doping, alloying and nanoprecipitation

Improving p-type thermoelectric performance of Mg2(Ge,Sn) compounds via solid solution and Ag doping

Multiscale microstructures and improved thermoelectric performance of Mg 2 ( Si 0.4 Sn 0.6 ) Sb x solid solutions

Enhanced thermoelectric properties of Mg2Si0.3Sn0.7 via Bi-doping under high pressure

Preparation and Thermoelectric Properties of Mg2Si1−xSnx

Thermoelectric performance improvement of p-type Mg3Sb2-based materials by Zn and Ag co-doping

Optimization of the thermoelectric performance of α-MgAgSb-based materials by Zn-doping

Cost Effective Synthesis of P-Type Zn-doped MgAgSb by Planetary Ball-Milling with Enhanced Thermoelectric Properties

Effect of Sb Doping on the Thermoelectric Properties of Mg<sub>2</sub>Si<sub>0.7</sub>Sn<sub>0.3</sub> Solid Solutions

Effect of Sb Doping on the Thermoelectric Properties of Mg 2 Si 0.7 Sn 0.3 Solid Solutions

High Figures Of Merit And Natural Nanostructures In Mg2si0.4sn0.6 Based Thermoelectric Materials

Roles of Interstitial Mg in Improving Thermoelectric Properties of Sb-doped Mg2Si0.4Sn0.6 Solid Solutions

Enhanced thermoelectric properties of p-type SnS0.2Se0.8 solid solution doped with Ag

Thermoelectric performance enhancement of Mg2Sn based solid solutions by band convergence and phonon scattering via Pb and Si/Ge substitution for Sn

Enhancing the Thermoelectric Performance of n‐Type Mg3Sb2‐Based Materials via Ag Doping

Thermoelectric properties of n‐type Mg<sub>2</sub>Si<sub>0.6–<i>y</i></sub>Sb<i><sub>y</sub></i>Sn<sub>0.4</sub>compounds

Thermoelectric properties of Sb-doped Mg2Si0.59Sn0.41solid solutions

Thermoelectric Properties of Sb-doped Mg2 Si0.59 Sn0.41 Solid Solutions

Thermoelectric performance enhancement of Pb-doped α -MgAgSb near room temperature

Realizing Cd and Ag codoping in p-type Mg3Sb2 toward high thermoelectric performance