Abstract:The plastic deformation behavior of metal plates has been proved to be affected by loading paths. Plastic flow is a critical component in the mechanical description of plastic deformation, like yield and hardening. In this work, the anisotropic plastic flow of two metal plates (16MnCr5 and S420MC) under non-proportional loading conditions was investigated. Large specimens manufactured along different orientations were pre-tensioned up to various strain levels; subsequently, small uniaxial tensile specimens were cut from the pre-tensioned specimens along different orientations with the interval of 15°, and then loaded to rupture. Meanwhile, the r-value, a measure of anisotropic plastic flow, was recorded. Result shows that for the studied plates which had constant r-value in the monotonic uniaxial tensile tests, a downward evolution of the r-value against plastic strain was observed when the Schmitt angle of two stage loading directions was greater than 90°. As the plastic strain in the subsequent loading stage accumulated, the r-value dropped from a higher level to its original level within a strain range about 6.0%. Based on the transient r-value evolution, a HEXAH-based evolutionary plastic potential model was constructed within the framework of non-associated flow (non-AF) theory. In the model, a local ellipse-shape distortion of the plastic potential surface was defined during plastic deformation process and when the Schmitt angel exceeded 90°, such distortion caused a downward evolution of the r-value in the subsequent deformation. The calibration result indicates that the model could reproduce the transient r-value response relevant to loading path change. The proposed evolutionary plastic potential model can be applied together with different anisotropic hardening models in the non-AF theory to give a detailed description of the plastic deformation behavior and hopefully provide a solution for the accurate simulation of the complex sheet metal forming process.

A Model of One-Surface Cyclic Plasticity with Lemaitre Damage Criterion for Plastic Instability Prediction in the Incremental Forming Process

Predicting the forming limits in the tube hydroforming process by coupling the cyclic plasticity model with ductile fracture criteria

A Model of One-Surface Cyclic Plasticity and Its Application to Springback Prediction

Multi-scale Modelling of Evolving Plastic Anisotropy During Al-alloy Sheet Forming

An Incremental Elastic-Plastic Cohesive Constitutive Model with Considering Damage

A NEW FORMULATION OF CONSTITUTIVE MODEL FOR HYPERELASTIC-CYCLIC PLASTICITY

A constitutive model of cyclic plasticity with Lode dependence for structural steels

A Metallic Constitutive Model Considering Damage Evolution and Bilinear Mixed Hardening

Constitutive Model for Full-Range Elasto-Plastic Behavior of Structural Steels with Yield Plateau: Formulation and Implementation

Integration Algorithm for a Modified Yoshida–Uemori Model to Simulate Cyclic Plasticity in Extremely Large Plastic Strain Ranges Up to Fracture

Damage-Plastic Constitutive Model of Thin-Walled Circular Steel Tubes for Space Structures

Evaluation and simulation on deformation instability mechanism in laminated sheet incremental forming

Dynamic Plastic Instability Prediction of Sheet Stretching by Using Elastic Crystalline-viscoplastic FE Method

A Simple Inelastic Constitutive Model for Evaluation of Stable Cyclic Stress Response under Nonproportional Straining

Enhanced CDM model accounting of stress triaxiality and Lode angle for ductile damage prediction in metal forming

Experimental and Modeling Investigation on Anisotropic Plastic Flow of Metal Plates under Nonproportional Loading Conditions

Constitutive modeling and deformation analysis for the ultrasonic-assisted incremental forming process

Research on incremental forming simulation based on an improved constitutive model

Modified Maximum Mechanical Dissipation Principle for Rate-Independent Metal Plasticity

Mixed hardening constitutive model of steel considering damage evolution

Cyclic plastic behavior analysis based on the micromorphic mixed hardening plasticity model