Abstract:Background Context The motion limitation after cervical discectomy and fusion alters the spine ́s kinematics. Unphysiological strains may be the result and possible explanation for adjacent segment degeneration. Alterations to cervical kinematics due to cervical total disc replacement (TDR), especially two-level, are still underinvestigated. Purpose To investigate cervical motion including coupled motions after one-level and two-level TDR in the treated and also the adjacent segments. Study Design An in-vitro study using pure moment loading of human donor spines. Methods Seven fresh frozen human cervical spine specimens (C4-T1, median age 46 with range 19-60 years, four female) were included in this study. Specimens were tested in the intact condition first, followed by one-level TDR at C5-6 which was subsequently extended one level further caudal (C5-7). Each specimen was quasistatically loaded with pure moments up to 1.5 Nm in flexion/extension (FE), lateral bending (LB) and axial rotation (AR) in a universal spine tester for 3.5 cycles at 1 °/s. During the tests three dimensional motion tracking was performed for each vertebral body individually. From that the primary and coupled ROM of each spinal level during the third full cycle of motion were evaluated. Non-parametric statistical analysis was performed using a Friedman-test and post-hoc correction with Dunn-Bonferroni-tests (p < 0.05). Ethics approval was obtained in advance. Results In FE, one-level TDR (C5-6) moderately increased primary FE in all four segments, but only significantly at the cranial adjacent level C4-5. Additional TDR at C6-7 further increased the ROM at the target segment without much influence on the other levels. Increasing implant height at C6-7 partially counteracted the increased FE. Coupled motions were minimal in all test conditions at all levels. In LB, coupled AR was observed in all test conditions at all levels. One-level TDR decreased primary LB at the target segment C5-6 significantly, without much influence on the other levels. Extending TDR to C6-7 decreased ROM in the target segment but without gaining statistical significance. Increasing implant height at C6-7 further decreased primary LB at the target segment, still without significance. Notably, coupled AR was significantly decreased at the cranial adjacent segment C4-5 compared to the intact condition. In AR, coupled LB was observed in all test conditions at the levels C4-5, C5-6 and C6-7, while the transition level to the thoracic spine C7-T1 showed only little coupled LB. Both one-level and two-level TDR showed little influence on primary AR or coupled motions at any level. Only after increasing implant height at C6-7 was the motion of the caudally adjacent level C7-T1 significantly altered. Conclusion Evaluating primary FE, LB and AR together with the associated coupled motions revealed widespread influence of cervical TDR not only on the motion of the treated level but also at the adjacent segments. The influence of two-level TDR is more widespread and involves more levels than one-level TDR. Clinical Significance The prevention of unphysiological strains due to altered kinematics after cervical fusion, which could possibly explain adjacent segment degeneration, were a driving factor in the development of TDR. These experimental findings suggest cervical TDR influences the whole cervical spine, not only the treated segment. The effect becomes more extensive, involving more levels and motion directions, after two-level than after one-level TDR.

In vitro study on biomechanical comparison between cervical arthroplasty and fusion

Biomechanical Comparison of One- and Two- Level Cervical Arthroplasty Versus Fusion

Biomechanics of Hybrid Anterior Cervical Fusion and Artificial Disc Replacement in 3-Level Constructs: an in Vitro Investigation.

Effects of cervical total disc replacement versus anterior cervical discectomy and fusion on biomechanics of the segments adjacent to the operation level

Comparison of the effect of the Prodisc-C cervical disc prosthesis and anterior cervical discectomy and fusion in one level cercical spoudyiosis

Biomechanical properties of a novel cervical spine implant with elastic deformation: a cadaveric study

Influence of Cervical Total Disc Replacement on Motion in the Target and Adjacent Segments

Biomechanical Characteristics of a Three-Level Cervical Disc Hybrid Construct: an in Vitro Investigation

Biomechanics of Artificial Disc Replacements Adjacent to a 2-Level Fusion in 4-Level Hybrid Constructs: an in Vitro Investigation

In Vitro Biomechanical Comparison after Fixed- and Mobile-Core Artificial Cervical Disc Replacement Versus Fusion

Comparison of the Mid-Term Follow-Up Results Between Bryan Cervical Artificial Disc Replacement and Anterior Cervical Decompression and Fusion for Cervical Degenerative Disc Disease

Finite element analysis of optimized novel additively manufactured non-articulating prostheses for cervical total disc replacement

Comparison of the Clinical and Radiographic Results Between Cervical Artificial Disk Replacement and Anterior Cervical Fusion A 6-Year Prospective Nonrandomized Comparative Study

External and internal responses of cervical disc arthroplasty and anterior cervical discectomy and fusion: A finite element modeling study

Artificial Disc and Vertebra System: a Novel Motion Preservation Device for Cervical Spinal Disease after Vertebral Corpectomy

3D printed anatomical bionic artificial cervical disc replacement for single-level cervical spondylosis: a cohort study

Comparisons of Three Anterior Cervical Surgeries in Treating Cervical Spondylotic Myelopathy

A comparative study of the effect of facet tropism on the index-level kinematics and biomechanics after artificial cervical disc replacement (ACDR) with Prestige LP, Prodisc-C vivo, and Mobi-C: a finite element study

Cervical Spine Balance of Multilevel Total Disc Replacement, Hybrid Surgery, and Anterior Cervical Discectomy and Fusion With A Long-term Follow-up

Randomized, controlled, multicenter, clinical trial comparing BRYAN cervical disc arthroplasty with anterior cervical decompression and fusion in China.

Finite Element Analysis Of Cervical Arthroplasty Combined With Fusion Against 2-Level Fusion