Abstract:Background Context The motion limitation after cervical discectomy and fusion alters the spine ́s kinematics. Unphysiological strains may be the result and possible explanation for adjacent segment degeneration. Alterations to cervical kinematics due to cervical total disc replacement (TDR), especially two-level, are still underinvestigated. Purpose To investigate cervical motion including coupled motions after one-level and two-level TDR in the treated and also the adjacent segments. Study Design An in-vitro study using pure moment loading of human donor spines. Methods Seven fresh frozen human cervical spine specimens (C4-T1, median age 46 with range 19-60 years, four female) were included in this study. Specimens were tested in the intact condition first, followed by one-level TDR at C5-6 which was subsequently extended one level further caudal (C5-7). Each specimen was quasistatically loaded with pure moments up to 1.5 Nm in flexion/extension (FE), lateral bending (LB) and axial rotation (AR) in a universal spine tester for 3.5 cycles at 1 °/s. During the tests three dimensional motion tracking was performed for each vertebral body individually. From that the primary and coupled ROM of each spinal level during the third full cycle of motion were evaluated. Non-parametric statistical analysis was performed using a Friedman-test and post-hoc correction with Dunn-Bonferroni-tests (p < 0.05). Ethics approval was obtained in advance. Results In FE, one-level TDR (C5-6) moderately increased primary FE in all four segments, but only significantly at the cranial adjacent level C4-5. Additional TDR at C6-7 further increased the ROM at the target segment without much influence on the other levels. Increasing implant height at C6-7 partially counteracted the increased FE. Coupled motions were minimal in all test conditions at all levels. In LB, coupled AR was observed in all test conditions at all levels. One-level TDR decreased primary LB at the target segment C5-6 significantly, without much influence on the other levels. Extending TDR to C6-7 decreased ROM in the target segment but without gaining statistical significance. Increasing implant height at C6-7 further decreased primary LB at the target segment, still without significance. Notably, coupled AR was significantly decreased at the cranial adjacent segment C4-5 compared to the intact condition. In AR, coupled LB was observed in all test conditions at the levels C4-5, C5-6 and C6-7, while the transition level to the thoracic spine C7-T1 showed only little coupled LB. Both one-level and two-level TDR showed little influence on primary AR or coupled motions at any level. Only after increasing implant height at C6-7 was the motion of the caudally adjacent level C7-T1 significantly altered. Conclusion Evaluating primary FE, LB and AR together with the associated coupled motions revealed widespread influence of cervical TDR not only on the motion of the treated level but also at the adjacent segments. The influence of two-level TDR is more widespread and involves more levels than one-level TDR. Clinical Significance The prevention of unphysiological strains due to altered kinematics after cervical fusion, which could possibly explain adjacent segment degeneration, were a driving factor in the development of TDR. These experimental findings suggest cervical TDR influences the whole cervical spine, not only the treated segment. The effect becomes more extensive, involving more levels and motion directions, after two-level than after one-level TDR.

Biomechanical Comparison of One- and Two- Level Cervical Arthroplasty Versus Fusion

In vitro study on biomechanical comparison between cervical arthroplasty and fusion

Biomechanics of Hybrid Anterior Cervical Fusion and Artificial Disc Replacement in 3-Level Constructs: an in Vitro Investigation.

Finite Element Analysis Of Cervical Arthroplasty Combined With Fusion Against 2-Level Fusion

Biomechanics of Artificial Disc Replacements Adjacent to a 2-Level Fusion in 4-Level Hybrid Constructs: an in Vitro Investigation

Motion Analysis of Single‐Level Cervical Total Disc Arthroplasty: A Meta‐Analysis

Biomechanical Characteristics of a Three-Level Cervical Disc Hybrid Construct: an in Vitro Investigation

Adjacent segment biomechanical changes after one- or two-level anterior cervical discectomy and fusion using either a zero-profile device or cage plus plate: A finite element analysis

Biomechanical Comparison of 1-Level Corpectomy and 2-Level Discectomy for Cervical Spondylotic Myelopathy: A Finite Element Analysis.

External and internal responses of cervical disc arthroplasty and anterior cervical discectomy and fusion: A finite element modeling study

Influence of Cervical Total Disc Replacement on Motion in the Target and Adjacent Segments

Biomechanical Analysis of Two-Level Novel Cage-Type Implant for Anterior Cervical Discectomy and Fusion: A Finite Element Analysis

Comparison of Multilevel Cervical Disc Replacement and Multilevel Anterior Discectomy and Fusion: A Systematic Review of Biomechanical and Clinical Evidence.

Biomechanical evaluation of adjacent segment degeneration after one- or two-level anterior cervical discectomy and fusion versus cervical disc arthroplasty: A finite element analysis

In Vitro Biomechanical Comparison after Fixed- and Mobile-Core Artificial Cervical Disc Replacement Versus Fusion

Biomechanics Following Skip-Level Cervical Disc Arthroplasty Versus Skip-Level Cervical Discectomy and Fusion: a Finite Element-Based Study.

Cervical Spine Balance of Multilevel Total Disc Replacement, Hybrid Surgery, and Anterior Cervical Discectomy and Fusion With A Long-term Follow-up

Effects of New Cage Profiles on the Improvement in Biomechanical Performance of Multilevel Anterior Cervical Corpectomy and Fusion: A Finite Element Analysis

A Comparison of 2 Anterior Hybrid Techniques for 3-Level Cervical Degenerative Disc Disease

Biomechanical Comparison of Different Surgical Strategies for Skip-level Cervical Degenerative Disc Disease: A Finite Element Study

The Kinematics and Biomechanics for Non-Contiguous Anterior Cervical Discectomy and Fusion, Cervical Disc Arthroplasty, and Hybrid Cervical Surgery: A Systematic Review