Abstract:Flat heat pipes can effectively spread a concentrated high power heat source in a small region into a larger heat dissipation area, which is widely used in the thermal management of electronic devices. In this paper, two different sintered copper powder wick structures are designed to study the effect of porous column height on the heat transfer performance. The results show that the best performance is achieved at the 30% filling ratio under the 15 degrees C cooling water with all the porous columns contacting with the condenser. The heat power is 312.7 W and the thermal resistance is 0.192 degrees C/W. As the cooling water temperature increases, the evaporation rate increases, resulting in a decrease in the thermal resistance. But the decrease in temperature difference causes the decline in heat dissipation power. Through the visual observation, it is found that the porous column contacting with the condenser can not only play the role of support and liquid reflow pathway, but also serve as an effective evaporation area to improve the heat transfer performance. While the low porous column cannot transport the condensed liquid and is completely immersed by the liquid under the high filling ratio, which is difficult to promote evaporation rate. In order to improve the performance at air cooling situation, an integrated heat pipe combined the flat heat pipe and fin tubes is designed, which can achieve a heat power of 259.8 W and present excellent temperature uniformity. This research provides the guidelines to optimize the heat transfer performance of porous column wick structures.

Heat Transfer Performance of Integrated Flat Plate Heat Pipe for LED Heat Dissipation

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Thermal Analysis of an Innovative Flat Heat Pipe Radiator

Simulation and optimization of high-power LED with flat heat pipe heat spreader

Heat Transfer Performance of Heat Pipe Radiator for High Power Integrated LED

Experimental Investigation on a Flat Heat Pipe Radiator for Cooling High Power LEDs

Experimental Study of an Integrated Aluminum Flat Plate Heat Pipe for Lightweight Thermal Management in Electronic Devices

Visualization research on influencing factors of flat heat pipes

Investigation of Heat Transfer Performance for an Integrated Heat-pipe Heat Exchanger Used for Electronic Components

Experimental investigation on thermal performance of a flat heat pipe

Study on Application of Heat Pipe Radiator in High Power LEDs for Street Lamp

Experimental and simulation study on flow heat transfer characteristics of flat pulsating heat pipe with wide and narrow interphase channels

Numerical and Experimental Investigation on Flat Heat Pipes With Integral Micro-grooved Wicks

Design and Analysis on Mirco Heat Pipe Cooling Solution for High Power LED Illuminator

Investigation on Transient Behaviors of Flat Plate Heat Pipes

Analysis of Heat Dissipation Performance for Typical High Power LED Secondly-heat Sinks

Visualization Study and Analysis on the Heat Transfer Performance of an Ultra-Thin Flat-Plate Heat Pipe

Research on Freeform Fabrication and Heat Transfer Performance of Integrated Ceramic Flat Heat Pipes

Experimental investigation on a 0.5-metre-long aluminum flat heat pipe for thermal management in electronic devices

Experimental Studies on a Novel Thin Flat Heat Pipe Heat Spreader

Experimental investigation of a flat plate heat pipe performance using IR thermal imaging camera