Abstract:Recently, flat heat pipes have been proposed for surface cooling applications to passively extract and recover thermal energy from hot surfaces. For instance, flat heat pipes have recently been proposed as thermal absorber for photovoltaic/thermal (PV/T) applications or for the thermal management of batteries. Following promising surface cooling results, increasing the fundamental knowledge of the two-phase heat transfer taking place inside such multi-channel flat heat pipes can participate to its widespread and lead to further improvement of the technology. Indeed, until now, the investigations have focused on the application only and not on the performance of the flat heat pipe itself. In this regard, this manuscript experimentally and theoretically investigates the thermal performance of a multi-channel flat heat pipe used for surface cooling applications. Heat transfer rates in the range 0–1500 W are studied and their impact on the boiling, condensation, and total thermal resistance of the multi-channel flat heat pipe is measured. In order to predict the thermal performance of the multi-channel flat heat pipe at all heat transfer rates, a theoretical model is proposed, which considers the impact of the multi-channel geometry. This model uses a multi-channel thermal resistance network. Furthermore, an important number of two-phase correlations for pool boiling and condensation are compared with experimental data and the optimum equations are integrated into the multi-channel model. As a result, over the whole range of heat transfer rates investigated, the proposed multi-channel flat heat pipe model was able to predict the boiling, condensation, and total thermal resistances of the heat pipe with an average error of 17.2%, 14.4% and 13.1%, respectively. Finally, the impact of the tilt angle is also studied, and infrared imaging of the flat heat pipe surface is presented.

Experimental Investigation on a Flat Heat Pipe Radiator for Cooling High Power LEDs

Study on LED Array Heat Radiator Improvement under Natural Convection

Thermal Analysis and Design of High-Power LED Street Light

Thermal Design Based on Thermosyphon Heat Sink of High-Power LED Street Light

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Study on LED array heat transfer under natural convection based on CFD

Experimental Study and Taguchi Analysis on LED Cooling by Thermoelectric Cooler Integrated with Microchannel Heat Sink

Orientation Effects on Natural Convection Heat Dissipation of Rectangular Fin Heat Sinks Mounted on LEDs

Experimental Study of Composite Heat Pipe Radiator in Thermal Management of Electronic Components

Experimental investigation of a flat plate heat pipe performance using IR thermal imaging camera

Orthogonal study and analysis of variance on a thermal management system for high-power LED package.

Experimental investigation on the thermal performance of a novel radiant heating and cooling terminal integrated with a flat heat pipe

Experimental investigation on a 0.5-metre-long aluminum flat heat pipe for thermal management in electronic devices

Experimental and theoretical investigation of the influence of heat transfer rate on the thermal performance of a multi-channel flat heat pipe

The Study on High-effect and Mechanism of Heat Dissipation of Tunnel LED

Experimental investigation on a flat loop heat pipe coupled with thermoelectric cooler

Study on collaborative enhancement of led heat dissipation characteristics by pulsating heat pipe and heat pipe

Influences of Heat Sink on Cooling Capability for LED Lamp

Experimental investigation of the thermal performance of high-temperature flat heat pipe with a single heat source and a multi heat source

Experimental investigation on thermal performance of ultra-thin flattened heat pipe with middle heating for electronics cooling

Experimental Study on the Thermal Performance of Flat Loop Heat Pipe Applied in Data Center Cooling