Abstract:Background: Residual limb discomfort and injury is a common experience for people living with lower limb amputation. Frequently, inadequate load distribution between the prosthetic device and the residual limb is the root cause of this issue. To advance our understanding of prosthetic interface fit, tools are needed to evaluate the mechanical interaction at the prosthetic interface, allowing interface designs to be evaluated and optimised. Objective: Present a methodology report designed to facilitate comprehension of the mechanical interaction between the prosthetic interface and the residual limb. As a pilot study, this methodology is used to compare a hands-on and hands-off interface for a single transtibial prosthesis user using secondary Magnetic Resonance Imaging (MRI) data. Methodology: MRI data of the residual limb while wearing a prosthetic interface is segmented into a hard tissue and a skin surface model. These models are exported as stereolithography (STL) files. Two methods are used to analyse the interface designs. Firstly, CloudCompare software is used to compute the nearest vertex on the skin surface for every vertex on the compiled internal bony surface for both interface types. Secondly, CloudCompare software is used to compare registered skin surfaces of the residual limb while wearing the hands-on and hands-off interfaces. Findings: The maximum and minimum nearest distances between the internal bony surface and skin surface were similar between interface types. However, the distribution of nearest distances was different. When comparing the skin surface while wearing both interfaces, where the fit is more compressive can be visualized. For the dataset used in this study, the classic features of a hands-on Patella Tendon Bearing interface and hands-off pressure cast interface could be identified. Conclusion: The methodology presented in this report may give researchers a further tool to better understand how interface designs affect the soft tissues of the residual limb.

3D Finite Element Dynamic Analysis of Interface Stress at Residual Limb of a Trans-Tibial Amputee

Effect of Dynamic Loads on the Interface Pressure at the Residual Limb of a Trans-Tibial Amputee

Dynamic Investigation of Interface Stress on Below-Knee Residual Limb in a Prosthetic Socket

A Quasi-Dynamic Nonlinear Finite Element Model to Investigate Prosthetic Interface Stresses During Walking for Trans-Tibial Amputees

[Inertial Effects on Interface Pressure Between Prosthetic Socket and Residual Limb].

3D Finite Element Analysis of a Man Hip Joint Femur under Impact Loads

The Investigation on a Quasi-Dynamic Finite Element Model to Predict Interface Pressure on Below-Knee Residual Limb

Load transfer mechanics between trans-tibial prosthetic socket and residual limb--dynamic effects.

Finite Element Modeling of the Contact Interface Between Trans-Tibial Residual Limb and Prosthetic Socket.

Pressure distribution at the stump/socket interface in transtibial amputees during walking on stairs, slope and non-flat road.

Methodology to Investigate Effect of Prosthetic Interface Design on Residual Limb Soft Tissue Deformation

Finite Element Analysis of Femoral Stress Changes after Total Hip Arthroplasty

Comparative study of a femoral amputated limb with and without implant

Stress Analysis and Shape Design of a Femoral Hip Prosthesis

Assessing Socket Fit Effects on Pressure and Shear at a Transtibial Residuum/Socket Interface

Finite element estimates of interface stress in the trans-tibial prosthesis using gap elements are different from those using automated contact

Dynamic effects on interface mechanics of residual limb / prosthetic socket system

Comparative biomechanical analysis of a conventional/novel hip prosthetic socket

Finite element modelling of a residual lower-limb in a prosthetic socket: a survey of the development in the first decade

Modulation of Internal Tissue Stresses of the Knee Via Control of Variable-Stiffness Properties in a 3D-Printed Footwear: A Combined Experimental and Finite Element Analysis

Simple modeling of stress transfer at interface of cemented prosthesis and femur