Abstract:This paper presents characterization and compensation of the thermal bias drift of a MEMS accelerometer whose effective stiffness is electrostatically tuned to a low value with the help of the single-sided parallel plates (SSPPs) capacitors. A temperature drift model for the proposed accelerometer is built and the temperature effect on the mechanical stiffness and the circuit gains is characterized. The characterization reveals that the variations of the feedforward coefficient including the mechanical stiffness and the readout gain due to the temperature change play a significant role in the bias drift of output of the proposed closed-loop accelerometer. On the other hand, the variations of both feedback gain and tuning gain as a function of temperature are one-order-of-magnitude less than that of the feedforward coefficient. To calibrate the feedforward coefficient, an excitation signal as a form of AC reference displacement is introduced to drive the proof mass and the readout response is demodulated to calibrate the variance of the feedforward coefficient correspondingly. An open-loop compensation scheme for the temperature-induced bias drift using the variance of the calibrated response is proposed accordingly. Alternatively, the calibrated response can be controlled to a preset value by a new proportion integral derivative (PID) controller by the adjustment of the SSPP tuning voltage. The output of the PID controller is used for the calibration of the introduced bias from the electrostatic tuning force. Therefore, a closed-loop compensation of the thermal bias drift is achieved by remaining the feedforward coefficient while eliminating the calibrated bias. Experiments under a temperature cooling process and different tuning voltages are carried out to verify two proposed compensation schemes. The temperature drift coefficients (TDCs) of both compensated outputs exhibit at least one-order-of-magnitude reduction in response to the temperature change. When the effective stiffness of the accelerometer is tuned to about 4.19 N m(-1), the TDC of the compensated output using the proposed open-loop or closed-loop compensation schemes is reduced to about 0.1136 or 0.0391 mg degrees C-1, respectively and meanwhile, the Allan bias instability is slightly increased to 48.63 or 56.14 mu g, respectively.

Effects of Preload Voltage on Performance of Force-Rebalance Micro Silicon Accelerometer

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Temperature and Preload Voltage Effect on Nonlinearity of MEMS Accelerometer

Study on the Mech Anical Stiffness of the Flexible Beams in a Micro-Machined Accelerometer

Design of Force-Balance Capacitive Accelerometer

A Real-Time Temperature Compensation Algorithm for a Force-Rebalanced MEMS Capacitive Accelerometer Based on Resonant Frequency.

Adapting adjustment of stiffness for force feedback micro accelerometer

A Stiffness-Tunable MEMS Accelerometer

Characterization and Compensation of Thermal Bias Drift of a Stiffness-Tunable MEMS Accelerometer

Servo Loop Design Of Capacitive Mems Accelerometer Under High Preload Voltage

A novel approach for preload measurement and analysis of fixed position preload spindle

Analysis and Optimization on Dynamic Characteristics and Important Parameters of Force Feedback Accelerometer

Design and Numerical Performance Analysis of a Microgravity Accelerometer with Quasi-Zero Stiffness

Experimental Study of Pre-Stressed Micromechanical Anti-Spring Structures.

EFFECT OF NON-PARALLEL PLATES OF FEEDBACK-BALANCED MICRO ACCELEROMETER ON RELIABLE OPERATION RANGE

Thermo-electro-mechanical Synergistic Effect on the Actuation Performance of Piezoelectric Stack

Identification and adjustment of the position and attitude for the electrostatic accelerometer's proof mass

Analysis & Prevention on Pull-in Failure of Force Feedback Micro-Accelerometer after Heavy Impact

Electrometric Method for Measuring the Mechanical Parameters of a Comb-Finger Micro-Mechanical Accelerometer

Influence of Preload on the Properties for Piezoelectric Stack Actuator

The Preload Force Effect on the Thermal Runaway and Venting Behaviors of Large-Format Prismatic LiFePO4 Batteries