Abstract:In this study, the influence of fractures on the mechanical properties and cracking behavior of composite rock mass was investigated by preparing rock-like specimens of composite rock mass with different dip angles of fractures using customized molds. The failure process of the sample was recorded using a camera, and the rock failure process analysis technology was used for quantitative investigation of the mechanical mechanism of crack evolution during the loading process of the sample. Based on the experimental results, the crack propagation and coalescence modes of fractured composite rock mass were analyzed, and the distribution laws of contact force chain and maximum principal stress during initial crack initiation were studied from the microscopic perspective. The results show that with the increase in fracture dip angle, when the fracture is located in hard rock, the peak strength of the specimen decreases first, then increases and then decreases. When the fracture is located in both soft rock and hard rock, the peak strength of the specimen is mainly controlled by the fracture in soft rock. The initial crack mainly occurs at the tip of the soft rock fracture, and then converges with the cracks developed at the end of the hard rock fracture through the interface. The crack propagation type and coalescence mode are affected by the joint action of the fracture dip angle and position. In total, eight crack propagation types and six crack coalescence modes were observed during the failure process. The maximum principal stress concentration area is distributed around the fracture and is "butterfly" type. With the increase in fracture dip angle, the maximum principal stress concentration area gets gradually deflected perpendicular to the fracture direction, and does not pass through the interface of soft and hard rocks. The existence of the interface prevents the transmission of stress to a certain extent.

CRACK DAMAGE AND GROWTH BEHAVIOR OF BRAIDED COMPOSITE

Research on the Impact Damage and Fracture Behaver of Braided Composites

Research Progress in Crack Propagation of Rubber Composites

Study of Cracked Unidirectional Glass Fiber-reinforced Composites by Digital Speckle Correlation Method

Dynamic Crack Growth in a Fiber-Reinforced Composite Plate

X-ray microtomography analysis of the damage mechanisms in 3D circular braided carbon fiber/epoxy resin composite tubes under axial impact compression

Dynamic Crack Propagation Behaviors of Woven Cloth Reinforced Composites

Fracture mechanism and fracture morphology of multi-dimensional braided carbon fiber/epoxy resin composites

Cracking Behavior of Cfrp Laminate-Strengthened Rc Beams with Premechanical and Postmechanical Environmental Damage

Effect of Microcracks on the Tensile Properties of 3D Woven Composites

Compressive Experimental Investigation of 3D 4-Directional Braided Composites Board on Mesoscopic Failure Mechanism

Dynamic Deformation Measurement of Woven Composite with Edge Cracks

Investigation of parameterized braiding parameters and loading directions on compressive behavior and failure mechanism of 3D four-directional braided composites

Optical Caustic Experimental Study on Crack Tip Singularity of Carbon Fiber Cloth Strengthened Beams

Mesoscale progressive damage and strength analysis of three-dimensional braided composites under tension

Experimental Investigation of Compressive Damage Mechanisms on 3-D Braided Composites by Acoustic Emission

Experimental Study of Dynamic Crack Growth in Unidirectional Graphite/Epoxy Composites using Digital Image Correlation Method and High-speed Photography

Experimental Studies on Fracture of Unidirectional Glass-Fibre-Reinforced Plastics Composites with V-Notch

Features of acoustic emission and micro‐CT of 3D‐printed continuous Kevlar fiber‐reinforced composites during progressive damage under flexural load

Micro-XCT Characterization and Numerical Analysis of Bending Damage Mechanism in Carbon Fiber Plain, Twill and Winding Composite Tubes

Mechanical properties and damage evolution characteristics of composite rock mass with prefabricated fractures