Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

3D Numerical Simulation of Parison Inflation in Extrusion Blow Molding

Growth Profiles of Parison Free Inflation in Plastics Extrusion Blow Molding

CAD/CAE Technique of Parison Inflation in Extrusion Blow Molding

A calculation method for average temperature distribution of extrusion blow molding parison sections

Numerical simulation and experimental investigation on parison formation from a varying die gap in extrusion blow molding

Study on Design and Optimization Techniques of Parison Thickness for Extrusion Blow Molding

Numerical Simulation of Injection-Stretch-Blow Molding Process

Constitutive Equations for Simulation of Parison Formation during Extrusion Blow Molding

A Three-Dimensional Thermal Model for Viscoelastic Polymer Melt Packing Process in Injection Molding

Constitutive Equations in Studying on Parison Formation Stage of Extrusion Blow Molding

Constitutive Equations for Numerical Simulation of PET Stretch Blow Molding

Simulations of a Full Three‐dimensional Packing Process and Flow‐induced Stresses in Injection Molding

Extrusion Blow Molding of 3D Duct of GF Reinforced PP

Analysis of Processing Conditions Affecting Part Quality in Extrusion Molding

Experiment and simulation of pet stretch blow molding process

Numerical Simulation of Flow-Induced Stresses in Mold Filling Process Using a Three-Dimensional Two-Phase Flow Model

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Numerical Study of Thickness Distribution of Stretch-Blow Bottles for Defects Prediction

Numerical Prediction and Experimental Validation of Viscoelastic Annular Swell

Mechanism of Plastics Extrusion Blow Molding

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament