Abstract:The paper provides the results of studies on interaction between titanium melts and silica-containing investment molds. Pure silicon, compounds of titanium oxides and silicides were detected by X-ray diffraction analysis in the contact zone. The problem of the negative impact exerted by the mold on the casting is solved by using thermally stable and chemically resistant monocorundum molds based on an alumina sol binder. A refractory suspension was developed for investment casting containing special additives to improve wax mold wetting with the suspension, and to increase the mold shell strength. The article studies sedimentation properties of suspension. A method was developed for accelerated curing of sequentially applied refractory suspension layers by vacuum drying and subsequent chemical curing with a gaseous reagent. The formation time is reduced from 3–5 h to 20–30 min per layer. Comparative studies of kinetics of alumina sol binder convective drying and vacuum dehydration were conducted. The process of moisture removal per unit surface of the applied refractory layer in a vacuum of 5–10 kPa increases by 2–6 times. X-ray phase analysis was used to study the alumina sol conversion during high-temperature heating. The solid gel of the α-Al 2 O 3 stable phase is obtained in the alumina sol mold shell when the calcination temperature rises to 1300–1350 °C with a sufficient strength of 9–12 MPa provided by sintering additives added to the suspension. Recommendations are given for additional protection of refractory ceramic layers after vacuuming and drying: treatment of the last layer with gaseous curing agents and application of a polyvinylacetal solution with a density of 1100–1200 kg/m 3 . The process solutions proposed will make it possible to increase both the efficiency of titanium alloy forming and casting processes and the quality of castings.

Research on Preparation Process of Quick Precision Casting Titanium Shell Based on SL Prototypes

Research and Development on Slurry of Precision Casting Titanium and Ti-alloy Abroad

The Study of Titanium Alloy Precision Casting Turbine Blades Based On Procast

Rapid Prototyping and Rapid Casting Process

The Design of 3D-Printed Lattice-Reinforced Thickness-Varying Shell Molds for Castings.

Effects of Process Parameters on Internal Quality of Castings During Novel Casting

Preparation, Characterization and Designing of Porous Ti–6Al–4V Through Metal Injection Molding Without Space Holder

Microstructure Evolution and Mechanical Properties of Ceramic Shell Moulds for Investment Casting of Turbine Blades by Selective Laser Sintering

Simulation Study on the Investment Casting Process of a Low-Cost Titanium Alloy Gearbox based on ProCAST

RAPID PROTOTYPING OF COMPLEX-SHAPED Al2O3 CERAMICS BY A LOST MOULD METHORD

Digital light processing 3D printing of ceramic shell for precision casting

Solid freeform fabrication of alumina ceramic parts through a lost mould method

Ceramic shell fabrication via Stereo Lithography Apparatus: Recent progress on cracking problems and preventive measures

New process solutions in the manufacture of thermochemically resistant ceramic molds for casting titanium alloys

Numerical Simulation and Process Optimization of Vacuum Investment Casting for Be–Al Alloys

Investment Casting Simulation and Analysis of Shell AlSi11 Alloy Part

Production of Ceramic Investment Casting Shells Using Lithography-Based Ceramic Manufacturing and Binder Jetting Technology

Surface Quality Improvement of Castings by Expendable Pattern Shell Casting with Vacuum and Low Pressure

Research on numerical simulation of investment casting process for gamma titanium aluminide turbocharger

An investigation of ceramic shell thickness uniformity and its impact on precision in turbine blade investment casting

Effects of Process Parameters on Shrinkage Porosity in 357 Semi-Solid Die Casting Parts