Abstract:The deformation limit of sheet metals predicted from forming simulations relies on the failure criteria employed. Localized necking and ductile fracture are two different failure mechanisms. They are applied to construct the Forming Limit Diagram (FLD) and Fracture Forming Limit Diagram (FFLD) in sheet metal forming processes. Recently, high strength steels and aluminum are extensively used as lightweight materials in road vehicle engineering to reduce fuel consumption. The deformation limit of those materials under stretch-bending condition shows significant bending radius dependent phenomenon. The bending process related to the stretch-bending loading of sheet metals is an out-of-plane effect, which has not been fully considered in traditional failure criteria. Most research efforts have been focused on the relationship between the localized necking phenomenon (ductile fracture) and the bending ratio (defined as the radius over the thickness). In this study, the different combinations of the tension and bending during the stretch-bending deformation referred as hybrid stretch-bending loading under the same bending ratio are investigated with proposed analytical models. The system instability and local material behavior are presented as two different failure mechanisms for forming limits and ductile fracture. Results from this study show that the localized necking failure is strongly affected by such loadings even under the same bending ratio. The final failure mode is a result of the competition between the localized necking and ductile fracture. It also suggested that the bending effect on forming limits is not just a function of the bending ratio but also a function of the specific hybrid stretch-bending loading applied on the sheet.

NUMERICAL ANALYSIS FOR THE DEFORMATION BEHAVIOR OF HYDRIDED ZIRCALOY-4 UNDER BIAXIAL PROPORTIONAL LOADING

Biaxial Low Cycle Fatigue Properties of Zircaloy-4 under Tension-Torsional Proportional Loading

MACROSCOPIC RESPONSE AND MICROSCOPIC MECHANISM OF ZIRCALOY-4 UNDER NONPROPORTIONAL LOADING

In Situ Observation of Tensile Deformation in the Recrystallized Zircaloy-4 after Hydridization

In-situ EBSD analysis of hydride phase transformation and its effect on micromechanical behavior in Zircaloy-4 under uniaxial tensile loading

Cyclic Deformation Behavior and Microscopic Mechanism of Cold-Worked Zr-4 Alloy under Biaxial Loading

Deformation behavior of hydrides in zircaloy-4 under biaxial fatigue

Non proportional loading behavior of 1Cr18Ni9Ti and Zr-4

Influence of Hydride Precipitation on Mechanical Behavior of Zircaloy-4 Sheets and FEM Simulation

On the mechanism of zircaloy-4 fatigue-deformation under different heat-treatment conditions

The Finite Analysis of Deformation and Stress Triaxiality of a Mixed I + II Mode Elastic-Plastic Crack Tip

Biaxial low cycle fatigue lifetime evaluation of zircaloy-4

Cyclic deformation behavior and dislocation substructures of hexagonal Zircaloy-4 under Out-of-Phase loading

Effects of deformation parameters and stress triaxiality on the fracture behaviors and microstructural evolution of an Al-Zn-Mg-Cu alloy

Effect of uniaxial loading direction on mechanical responses and texture evolution in cold pilgered Zircaloy-4 tube: Experiments and modeling

Complex Stress-Strain Relations of Tubular Materials Studied with A Flexible Hydroforming System

Numerical and Experimental Fracture Study for 7003 Aluminum Alloy at Different Triaxialities

Theoretical failure investigation for sheet metals under hybrid stretch-bending loadings

Calibration and Application of Ductile Fracture Criterion under Non-Proportional Loading Condition

Broad Stress Triaxiality Ratio Band Fracture Experiments in DP900 Metal Sheets and Corresponding Predictive Capability of Advanced Phenomenological and Micromechanical Fully Coupled Damage Models

Numerical Analysis of the Crack-Tip Stress Field in Pure Aluminum Sheet Constrained by Interfaces