Abstract:Innovating new approaches and effective methods to improve the efficiency of mechanical systems in terms of energy losses and environmental effects serve as an attractive domain for researchers and industries. Wet clutches are widely used in power transmission systems in automotive and other tribological mechanisms. The wet clutch has two functional modes; under the engaged state, in which two disks come into contact to each other, and under disengagement the plates are located at a very short distance from each other, and oil flows between them. In disengaged state, the differential speed of driving and driven units causes oil shearing within the clearance which leads to transmission of certain amount of drag torque from the driving to the output shaft. This transferred drag torque is distinguished as power loss in form of heat. The governing physical relation based on continuity equation and Navier–Stokes equations reveals that in a certain rotational velocity, the pressure gradient at the outer radius of the clutch becomes null, and, in this circumstance, aeration occurs that is known as critical rotation speed. Experimental findings provide evidence that geometry manipulation and considering grooves over the frictional disk, reduces the critical rotational speed. But there is a shortage of physical analytical relations to predict the pressure gradient in grooved wet clutches. Therefore, this article is aimed to introduce analytical model to evaluate grooved wet clutches performance in terms of drag torque and critical rotational speed under single-phase flow condition.

A NUMERICAL SIMULATION OF TRANSIENT YIELD SURFACES OF ELECTRORHEOLOGICAL FLOWS IN CONCENTRIC CLUTCH

Transient Characteristics of the Yield Surface of Electrorheological Clutch

Thermodynamics-based bounding surface model for overconsolidated clay

Simulation and Experiment on Dynamic Engagement Characteristics of Wet Clutch

A Bounding Surface Model for Anisotropically Overconsolidated Clay Incorporating Thermodynamics Admissible Rotational Hardening Rule

Transient Yield Characteristics Of Er Fluids Between Rotary Concentric Cylinders

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Experimental and Theoretical Analysis of the Drag Torque in Wet Clutches

Simulation Research on the Drag Torque of Disengaged Wet Clutches

Finite Element Analysis for Temperature Field of Clutches Based on B-spline Wavelet

Characteristics Of Electrorheological Fluid Flow Between Two Concentric Cylinders

Investigation of thermal behavior of a novel multi-conical friction pair during wet clutch's engagement based on finite difference method

Simulation Of Wet-Clutch Short-Time Load End Speed Control System On Amesim

Squeezing Flow of Electrorheological Fluid Between Two Circular Plates

Transient temperature characteristics of friction clutch disc considering thermal contact conductance under sliding conditions

Couette Flow of Electrorheological Fluids Between Two Concentric Cylinders with Wall Slip

Boundary Effect in Electrorheological Fluids.

Investigation of Different Groove Profile Effects on Torque Transmission in Shear Mode Magnetorheological Clutch: Numerical Simulation and Experimental Study

Compressions of Electrorheological Fluids under Different Initial Gap Distances

Analytical simulation of influential parameters affecting grooved wet clutches performance underdisengagement condition

STUDY ON CHARACTERISTICS OF AN ELECTRORHEOLOGICAL FLUID COUPLING