Abstract:The present paper introduces the stray light and bandpass correction methods for spectrometers. The line spread function of spectrometer is characterized by a He-Ne laser. Assuming that the spectrometer is a wavelength invariable system, the stray light distribution matrix is constructed by the derived line spread functions. The stray light correction matrix is then derived by matrix conversion from the stray light distribution matrix. The measured signals of the spectrometer are finally multiplied by the stray light correction matrix to correct the stray light errors. The bandpass functions of the spectrometer are characterized in three different wavelength ranges, respectively. And then three groups of bandpass correction coefficients are calculated accordingly. The calculation is divided into several steps. Given the measurement results at the target wavelength position and the ones on the neighbor bandwidths, the bandpass correction results are obtained by weight averaging of them. The bandpass correction coefficients are used as the weights. The two correction methods are applied to a multi-channel fast spectrometer to measure LEDs of different color. The results show that the stray light and the bandpass errors can be corrected effectively. The chromaticity coordinates of the LEDs are corrected by (-0.003, 0.007) for the maximum. Furthermore, the method introduced in this paper can reduce the application cost, simplify the calculation under a reasonable precision, and make the application of the correction easier.

Experimental design of measuring the effect of peak wavelength shift of LED on chrominance

Stray light errors in spectral colour measurement and two rejection methods

Stray Light And Bandpass Correction In The Spectral Measurement For Light Emitting Diodes

Spectrum measurement for LED-based spectrum-tunable source

Accelerated Life Test for High-Power White Led Based on Spectroradiometric Measurement

Fast and High-Accuracy Spectral Measurements of LED by Linear CCD Sensor and Software Calibration

Design of Experiment of Chromaticity Measuring for LED

Improving Peak-Wavelength Method to Measure Junction Temperature by Dual-Wavelength Leds

Study On Chromaticity Balance For Led Exposure System

Study on a system for LED's photometric and colorimetric measurement based on a multi-channel spectrometer

Design Of Led Dimming System With The Specific Target Parameter Control Function

A novel technique for rapid measurement of LED spatial chromaticity and photometric distribution

Study on a Spectrophotometer System for Measuring LED's Photometric Parameters

Discussion about problems in measuring photometric and colorimetric parameters of LED

Measurement model of circadian action factor of phosphor-converted white LEDs based on photometric, electrical, and thermal properties

A research of laboratory instrument for LED property measurement

A Spectral Transmission Measurement System of LED Optical Lens

An Improvement on the Junction Temperature Measurement of Light-Emitting Diodes by Using the Peak Shift Method Compared with the Forward Voltage Method

Wavelength Dependence of Colorimetric Properties of Lighting Sources Based on Multi-Color LEDs

Spectral Effect of multi-chip LED on Color Contrast Sensitivity with SPD Tuning

Design of Optocoupler for Synthesizing Four Color Spectra