Abstract:The SAGD start-up process normally circulates steam in both the injector and producer, which consumes a large amount of steam, requires the high cost of high-temperature-produced liquid treatment, and unavoidably results in preferential communication in heterogeneous reservoirs. In order to achieve uniform preheat and full steam chamber development in SAGD wellpairs, downhole electrical heating to start up SAGD was proposed and investigated in this study using physical and numerical simulation approaches. Two 3-D scaled physical experiments were designed and implemented to investigate the feasibility and heating characteristics of such a method. Numerical simulation was conducted using an SAGD sector model with typical field properties to design the preheating process, optimize key operational parameters, and formulate the soak strategy to determine the SAGD conversion timing. The experimental results indicate that electrical heating outperforms steam circulation in achieving the uniform thermal communication in heterogeneous reservoirs, which is challenged in the conventional steam circulation process. The preheating process and operational parameters of electrical heating were formulated and optimized, which include wellbore pre-flush, wellbore saturation by heat conduction fluid, electrical heating, and replacement of heat conduction fluid periodically. Surveillance of temperature difference along the horizontal section while powering off electrical heating intermittently is optimized to be the SAGD conversion timing determination strategy. Based on the combination results of scaled physical simulation and pilot wellpair numerical simulation, full heat communication and steam chamber development are achieved along the horizontal length by electrical preheating, and the oil recovery factor of the pilot wellpair is enhanced by 14.8%, indicating encouraging potentials in heavy oil and bitumen development.

The systematic construction and electric-controlled principle on automatic electrothermic steam generator

A Study on the Electro-hydraulic Control Systems Based on the New Type Valve for Steam Turbines Fast Valving

Applied Study of Electrothermal Membrane Heating Technique in Crude Oil Gathering System

Electrically Driven Interfacial Evaporation for High-Efficiency Steam Generation and Sterilization

Application of Multi-Tangential Firing Technology to Settling the High Temperature Corrosion of Water Wall Tube of Boiler

Theoretical Research on the Steam Power Cycle with Self- Pressure Lifting Technology

Experimental technique based of an innovative heating method for the wetness measurement of flowing wet steam

Design of regenerative high temperature pressured steam generator

Researches On The Performance Of Steam Injector For District-Heating System

Research on Plasma Iginition Technique in Power Station Boiler

Regenerative High Temperature Steam Production

AUTOMATIC NONDESTRUCTIVE INSPECTION SYSTEM FOR PRESSURIZED TUBING OF HEAT EXCHANGE IN UTILITY BOILERS

Detection and Control of Regenerative High Temperature Pressured Steam Generator

The emergence of solar thermal utilization: solar-driven steam generation

RESEARCH AND DESIGN OF MECHANICAL EQUIPMENT FOR TAKING AND PREPARING COAL SAMPLES FROM INGOING TRAIN WAGONS TO POWER PLANTS

High Temperature Corrosion Mechanism and Robot Detection Technology of the Water Wall Tube

Strategies of SAGD Start-Up by Downhole Electrical Heating

Automatic Welding System Design for Connecting Piece of Heating Surface Piping of Ultra Supercritical Boiler

Present and Prospect of Power Equipment's Electriferous Cleaning Technique

The Preference of Steam-water Two-phase Flow Direct Contact Pressure-lifting Heater