Abstract:Due to native deficiency of the interfacial mismatch between Al2O3 and Al-melt, as well as micron-Al2O3 segregation at matrix grain boundaries (GBs), achieving both high strength and fracture toughness has been the long-lasting challenge for Al-CuO composite fabricated by conventional casting. Herein, we report a novel manufacturing of Al-CuO composite via shift-speed ball-milling (SSBM) of Al-5 wt.% CuO powders and afterwards subjected to hot-pressing (HP) as well as heat treatment. Comprehensive characterization shows that in-situ generation of the two types of Al2O3 with intragranular distribution, including δ*-Al2O3 particles (∼200 nm) and γ-Al2O3 whiskers (length of ∼150 nm, thickness of ∼20 nm), was governed by a diffusion-assisted nucleation-regime ascribing to the intense thermal effect of Al-CuO reaction. The size and spatial distribution of Al2O3 were emphasized to address their contribution to the high mechanical performance of the composite, which exhibits a tensile strength of ∼481 MPa and fracture elongation of ∼16.8 %. Meanwhile, the toughening mechanism of present Al-CuO composite was rationalized on basis of the "dislocation punched zone" and "plastic zone" affected by Al2O3. Both the theoretical analysis and fracture morphology support a reinforcements-matrix interface failure mechanism and the non-uniform distribution of Al2O3 consisting alternant "rich/poor zones" can markedly contribute to the high toughness. The present findings may provide a promising strategy to achieve an intragranular distribution of nano-sized reinforcements in Al-metal oxides composites, which enables increasing strength and ductility of the metal matrix.

Fabrication Techniques and Research Situation of Cu-Al2O3 Composites

Research progress on preparation technology of graphene-reinforced aluminum matrix composites

Investigation on Microstructure and Properties of Cu–Al2O3 Composites Fabricated by a Novel In-Situ Reactive Synthesis

Study of Hot-press Sintering Process of Nanometer Cu-Al_2O_3 Composite

The Progress of W-Cu Composite Materials Preparation Technique

Progress and Current Status in Research on Nanostructured Cu-Ag Microcomposites for Conductor Wires

Fabrication and Microstructure of C/Cu Composites

In situ fabrication and microstructure of Al2O3 particles reinforced aluminum matrix composites

Current situation of ultrafine W-Cu composite powders preparation

Synthesis and characterization of an in-situ Al2O3/Al–Cu composite with a heterogeneous structure

Influence of Cu content on interfacial microstructure of Al2O3-SiO2 fiber reinforced Al matrix composites

Recent Advances in W–Cu Composites: A Review on the Fabrication, Application, Property, Densification, and Strengthening Mechanism

Effect of Cu Content on Microstructure and Properties of Al2o3-Sio2 Fiber Reinforced Aluminum Matrix Composites

Revealing the strengthening and toughening mechanisms of Al-CuO composite fabricated via in-situ solid-state reaction

Research Progress on Copper/Aluminum Bimetal Composite

A Novel Way for Fabricating Ultrafine Grained Cu-4.5 Vol% Al2O3 Composite with High Strength and Electrical Conductivity

Influence of Fe and Al2O3 Addition on the Mechanical and Tribological Properties of Cu-Based Composites

Influence of adding Cu element on properties of Al/Al2O3 composite materials

Influence of Cu content on interfacial structure and mechanical properties of 3Al2O32SiO2 fiber reinforced Al matrix composites

Ultrafine W-Cu Composite Powder Research Progress

Fabrication of in situ Al2O3/Al composite via remelting