Abstract:The development of sensitive fiber-optic accelerometers is a subject of continuing interest. To acquire high resolution, Michelson phase interferometric techniques are widely adopted. Among the variety structures, the compliant cylinder approach is particularly attractive due to its high sensitivity that is defined as the induced phase shift per applied acceleration. While the two arms of Michelson interferometer should be at the same optical path, it is inconvenient to adjust the two arms' length to equal, also the polarization instability and phase random drift will cause a signal decline. To overcome these limitations, a novel optical fiber accelerometer based on differential interferometric techniques is proposed and investigated. The interferometer is a Sagnac-like white light interferometer, which means the bandwidth of laser spectrum can be as wide as tens nanometers. This interferometer was firstly reported by Levin in 1990s. Lights are divided to two paths before entering the coupler. To induce time difference, one passes through a delay arm and another goes a direct arm. After modulated by the sensing component, they reflect to opposite arm. The sensing part is formed by a seismic mass that is held to only one compliant cylinder, where the single-mode optical fiber is wrapped tightly. When sticking to vibrations, the cylinder compresses or stretches as a spring. The corresponding changes in cylinder circumference lead to strain in the sensing fibers, which is detected as an optical phase shift by the interferometer. The lights from two arms reach the vibration source at different time, sensing a different accelerate speed; produce a different optic path difference. Integrating the dissimilarity of the accelerated speed by time can obtain the total acceleration graph. A shaker's vibration has been tested by the proposed accelerometer referring to a standard piezoelectric accelerometer. A 99.8% linearity of the optical phase shift to the ground acceleration is achieved. The acceleration sensitivity is 300 rad/g. It proves to have a simple structure, good practice, reliable measurement and stable performance.

Design and Experiment of All Polarization-maintaining Fiber-optic Vector Accelerometer

Theoretical and Experiment Research on Polarization Parameters Test System of Fiber-optic Gyroscopes

Research on Polarization Parameters Testing System

Development of Method for Polarization Alignment of PANDA Polarization Maintaining Fiber

Research On Accelerometer Based On Multi-Mode Interference

Research on a Dual Polarization-Maintaining FBG Accelerometer

A Novel Differential Optical Fiber Accelerometer

A New Fiber Optic Accelerometer with Push-Pull Structure Using 3×3 Coupler

Sensitivity Enhancement Method for Dual-Polarization Interferometric Fiber-Optic Angular Accelerometer

Fiber Optic Accelerometer Based on Fiber-Mirror Interference Cavity

FFT Algorithm-Assisted Polarimetric Twist Sensor

A 3-Component Fiber Optic Accelerometer for Well Logging

Theoretical Model and Design of Highly Sensitive Reflective Fiber Optic Fabry-Pérot Cavity Accelerometer Independent of Fiber Stiffness

3-component fiber optic accelerometer for well logging

Three-component Bellows-Type Fiber Optic Accelerometer

Research on Stability of Polarization in an All-fiber Position Determination System

Reducing Polarization-Fluctuation Induced Drift in Resonant Fiber Optic Gyro by Using Single-Polarization Fiber.

Nondestructive Measurement Of Polarization Characteristics Of Fiber-Pigtailed Waveguide-Type Ring Resonators

Research of Stress Sensing Based on Measurement of Polarization Coupling in Polarization-Maintaining Fiber

Angular Accelerometer Based on a Dual-Polarization Fiber-Optic Sagnac Interferometer.

Design the Structure of High-g Optical Microcavity Accelerometer