Abstract:Welding is widely used to make assembly of structural components and it will trigger serious environmental pollution, especially waste gas, i.e., carbon dioxide (CO 2 ), ozone (O 3 ), nitrogen oxide (NO x ), and particulate matter (PM). It is hard to accurately measure gas pollutants because of their fluidity and diffusivity. However, the pollutants could be evaluated by exploring its generation procedure, i.e., how these pollutants are produced and how to quantify these pollutants. In this paper, an arc profile–based approach to evaluate the emissions of gas pollutants in welding was proposed. The emission of gas pollutants in welding can be calculated according to the chemical reaction and corresponding reaction condition, i.e., the intensity of discharge that determines the coverage volume of the welding arc. To obtain the coverage volume, the welding arc was observed using a high-speed camera and the arc edge was extracted and reconstructed by a binarization processing based method. A welding experiment was performed for recording the arc shape and measuring the emission of gas pollutants. Results show that the measured concentrations of NO x and O 3 are 70% and 79% of the calculated emissions of gas pollutants, respectively. It demonstrates the proposed method is credible and feasible, which can help quantitatively analyze the emission of gas pollutants. Meanwhile, the influence of welding time, welding current, and arc length on the emission of gas pollutants was investigated for lowering emission of gas pollution in welding, in order to support the development of sustainable manufacturing processes.

Current Development and Trend of Quality Evaluation Techniques for CO2 Arc Welding Process

Research progress of low spatter CO2 welding technology

Synthetically quantitative evaluation function of characteristic parameters on CO2 arc welding process

Welding Process Carbon Footprint Analysisand Process Parameters Optimization

Study on Arc-ultrasonic Improving Overlaying Welding and Thermal Spaying Quality

Analysis and control of short-circuit experience in short-circuit CO2 welding

Sensing and Control System of Process Quality in Co2 Laser Deep Penetration Welding

Current status of research on numerical simulation of droplet transfer in CO2 gas–shielded welding

An arc profile–based approach to evaluate gas pollutants in welding

Study on self-optimizing function for intelligent control of CO2 welding

Finite element simulation of welding process and real-time monitoring assessment

Cross-scale process quality control of variable polarity plasma arc welding based on predefined temperature field

A review of quality monitoring for ultrasonic metal welding

Keyhole Detection by Arc Voltage Signal Processing During Plasma Welding

Fuzzy Adjustment of Arc Current in Short-Circuiting CO2 Welding

Microstructure and Mechanical Properties of a Weld Seam from Magnetron High-Current CO2 Welding

Effective Control Approach on Molten Droplet Size in Waveform Controlled Short Circuit Co2 Arc Welding

A novel optimizing Pulsed Plasma Gas Variable Polarity Plasma Arc Welding (PPG-VPPAW) method for improving weld quality

Study on Side Assist Blowing Gas with Different Composition in High Power CO_2 Laser Welding

Quality Evaluation of Resistance Spot Welding Based on Dynamic Reactance Signal and Radar Diagram Method

On-Line Monitoring and Defects Detection of Robotic Arc Welding: A Review and Future Challenges