Abstract:A novel gain-clamped erbium doped fiber amplifier (EDFA) based on ring erbium-doped fiber laser is demonstrated.This new design provides a good gain clamping as well as a gain flattening without any gain flattening filter.12m long low erbium doped fiber was used as gain medium pumped by 980nm laser diode(LD).The 30nm flattened amplification bandwidth was obtained with forward pumping.By means of the 1520nm feedback laser the gain was clamped at 16dB.The gain characteristics against input signal power for both open-ring and the gain-clamped systems with different VOA losses were experimented,when the input power level increased from-40dBm to 10dBm,the signal gain was performed stabilization.The gain ripple was less than 0.1dB from input signal power -40dBm to 0dBm by settling the VOA at 2dB where the amplifier had a flatter gain spectrum.Small signal gain of 20dB was achieved at 1550nm with input power of-40dBm and the saturated output power could reach to 16dBm.Experimental results show that the signal gain was clamped and this gain-damped erbium fiber amplifier could support a 40 channel WDM system.

Theoretical analysis of gain-clamped results for an EYDFA

Low noise characterization of gain-clamped erbium-doped fiber ring-lasing amplifiers

Low Noise-Figure Gain-Clamped L-band Double-Pass Erbium-Doped Fiber Ring Lasing Amplifier with an Interleaver

The Characteristic Investigation of Gain-clamped EDFA

Theoretical Analysis on Gain Characteristics of Ytterbium-Doped Fiber Amplifier

Gain-Clamped Erbium-Doped Fiber-Ring Lasing Amplifier with Low Noise Figure by Using an Interleaver

The Global Analysis for an All-Optical Gain-Clamped L-band Erbium-Doped Fiber Amplifier Using a Single Fiber Bragg Grating

Gain clamping in L-band erbium-doped fiber amplifier using a fiber Bragg grating

An Erbium-Doped Fiber Amplifier With Tunable Gain-Clamping in the Extended L-Band

Simulation of gain-clamped L-band erbium doped fiber amplifier using single fiber grating

Characteristics of the bandwidth in gain-clamped erbium-doped fiber amplifiers

The theoretical analysis and simulation of double cladding Er/Yb Co doped optical fiber laser

Gain and Noise in Ytterbium-Sensitized Erbium-Doped Fiber Amplifiers: Measurements and Simulations

Tunable Gain-Clamped Double-Pass Erbium-doped Fiber Amplifier.

Gain Characteristics of Er~(3+)/Yb~(3+) Co-Doped Waveguide Amplifiers

Analysis of Gain Distribution in Cladding-Pumped Thulium-Doped Fiber Laser and Optical Feedback Inhibition Problem in Fiber-Bulk Laser System

Tunable, Gain-Clamped Double-Pass Erbium-Doped Fiber Amplifier with A Dbr Lasing Cavity Including A Fiber Bragg Grating and A Fiber Reflection Mirror

Tunable, gain clamped double pass Erbium doped fiber

Low Noise Figure All-Optical Gain-Clamped Parallel C+L Band Erbium-Doped Fiber Amplifier Using An Interleaver

Study on noise figure and gain of EDFA

Optimal design of Er/Yb co-doped fiber amplifiers with an Yb-band fiber Bragg grating