The Characteristic Investigation of Gain-clamped EDFA

Zhixin Zhang

2006-01-01

Abstract:A novel gain-clamped erbium doped fiber amplifier (EDFA) based on ring erbium-doped fiber laser is demonstrated.This new design provides a good gain clamping as well as a gain flattening without any gain flattening filter.12m long low erbium doped fiber was used as gain medium pumped by 980nm laser diode(LD).The 30nm flattened amplification bandwidth was obtained with forward pumping.By means of the 1520nm feedback laser the gain was clamped at 16dB.The gain characteristics against input signal power for both open-ring and the gain-clamped systems with different VOA losses were experimented,when the input power level increased from-40dBm to 10dBm,the signal gain was performed stabilization.The gain ripple was less than 0.1dB from input signal power -40dBm to 0dBm by settling the VOA at 2dB where the amplifier had a flatter gain spectrum.Small signal gain of 20dB was achieved at 1550nm with input power of-40dBm and the saturated output power could reach to 16dBm.Experimental results show that the signal gain was clamped and this gain-damped erbium fiber amplifier could support a 40 channel WDM system.