Abstract:The DPF regeneration is crucial for reducing backpressure, minimizing negative impacts on engine power and fuel economy, but the changes in particulate emission characteristics it brings are worth studying. In this study, the influence of DPFs with different soot loadings on exhaust back pressure and particle emission characteristics, as well as the particle number emission, particle size distribution, and thermal field distribution characteristics during regeneration was investigated based on engine bench test. Results reveal that the exhaust back pressure increases linearly with the engine speed, as well as the soot loading. The increase of DPF soot loading leads to a considerable increase in the reduction efficiency of particle number (PN) and particulate matter emissions, especially for the accumulation mode particles. Moreover, the performance in reducing nucleation mode particles is markedly better than that of accumulation mode ones, and this effect is greatly influenced by the engine operating conditions. At the beginning of DPF regeneration, the PN concentration increases sharply, especially the nucleation mode particles. After regeneration, the PN emissions decrease by two orders of magnitude. During regeneration, the particle size distribution exhibits a unimodal distribution, with the peak value increasing considerably and shifting toward smaller particle sizes. After regeneration, the particle size of the PN peak value slightly decreases and markedly shifts toward larger sizes, the accumulation mode particle concentration increases by 7.2 times, and the nucleation mode particle concentration increases by 2.6 times. Before the DPF regeneration, the axial temperature gradually decreases along the direction of the airflow, and the radial temperature gradually decreases from the center to the edge. During regeneration, the highest temperature occurs in the center of the DPF cross-section, whereas the temperature peak at the outlet interface occurs at the middle position of the DPF. The findings of this paper can provide scientific references to formulation and optimization of DPF regeneration strategies.

Experimental Investigation on the Influence of Filtration Velocity on Particulate Deposition Characteristics in DPF

Experimental Study on the Influence of DPF Micropore Structure and Particle Property on Its Filtration Process

Experimental Investigation on Deposition Configuration of Soot Layer in Diesel Particle Filter

Study of the Influence of Methanol/f-T Diesel Combustion Particle Materiality Parameters on the Deposition Process in Diesel Particulate Filter Trap Units

Experimental Investigation on the DPF High-Temperature Filtration Performance under Different Particle Loadings and Particle Deposition Distributions

Comparison of the Use of Real Diesel Soot and Soot Surrogate in the Performance Analysis of Diesel Particulate Filters

Investigation of Adsorption Characteristics and Influencing Factors for Diesel Engine Exhaust Particles

Lumped model for evaluating dynamic filtration and pressure drop behaviour in diesel particulate filters

Numerical simulation of diesel particulate filter flow characteristics optimization: From the perspective of pore structure parameters and inlet velocity

An Assessment of the Application of Catalyst Preheating Prior to Engine Cold Start to Improve the Filtration Performance of CDPF on Particulate Emissions

EXPERIMENTAL INVESTIGATION ON THE INFLUENCE OF WALL-FLOW DIESEL PARTICLE FILTER PARAMETERS ON FILTER PERFORMANCE

Particle filter performance of soot-loaded diesel particulate filter and the effect of its regeneration on the particle number and size distribution

Analysis of the effect of particle–wall collision process in DPF on the spatial structure of smoke cake layer

An Experimental Investigation of the Impact of Washcoat Composition on Gasoline Particulate Filter (GPF) Performance

Numerical Investigation into the Non-uniform Soot Layer Distribution in a Diesel Particle Filter

Novel soot loading prediction model of diesel particulate filter based on collection mechanism and equivalent permeability

Filtration Efficiency and Regeneration Behavior in a Catalytic Diesel Particulate Filter with the Use of Diesel/Polyoxymethylene Dimethyl Ether Mixture

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines.

Methodology of diesel particulate filter testing on test bed for non-road engine application

An experimental investigation of particulate emission characteristics of catalytic diesel particulate filters during passive regeneration

The Effects Of Doc And Dpf On The Particulate Properties Of Diesel Engine