Abstract:Error calibration is one of the most important factors to realize the quadri-wave lateral shearing interferometer (QWLSI) with high accuracy. The misalignment errors of QWLSI, such as the tilt of grating and the tilt of charge coupled device (CCD), will affect the measurement accuracy. The astigmatism errors induced by the tilt of grating and CCD during the alignment process of QWLSI, which are neglected in previous studies, are analyzed and presented in analytical expressions in this paper. Firstly, the additional phase difference in X and Y directions induced by the tilt of grating and CCD are analyzed using the optical wave interference theory. Representing the phase difference in the two directions and the test wavefront with the combinations of Zernike polynomials respectively, we further obtain the analytical expressions between the Zernike coefficients of the phase difference and the Zernike coefficients of the test wavefront, according to the wavefront reconstruction theory. Then the analytical expressions for the measurement errors induced by the tilt of grating and CCD, which are mainly astigmatism, can be obtained. The analytical results show that the misalignment induced astigmatism errors are inversely proportional to the shearing ratio and proportional to the tilt angle of grating and CCD. The alignment experiment of a home-made QWLSI under null test condition is conducted to verify the correctness of the theoretical analysis. With different shearing ratios for the QWLSI, the astigmatism errors, which are induced by the tilt of grating in experimental results, are consistent with the theoretical analysis results. This paper can provide technical support for the alignment of QWLSI with small shearing ratio and high precision.

Confocal Position Alignment in High Precision Wavefront Error Metrology Using Shack-Hartmann Wavefront Sensor

Alignment Methods for Micron-Scale Surface Defects Automatic Evaluation of Large-Aperture Fine Optics

Learning-based Shack-Hartmann Wavefront Sensor for High-Order Aberration Detection.

Misalignment Correction for Free-Form Surface in Non-Null Interferometric Testing

Common-path and compact wavefront diagnosis system based on cross grating lateral shearing interferometer.

High numerical aperture Hartmann wavefront sensor with pinhole array extended source

Practical and Accurate Method for Aspheric Misalignment Aberrations Calibration in Non-Null Interferometric Testing

Alignment Technique of Slope and Curvature Hybrid Wavefront Sensor Based on Scalar Diffraction Theory

A Novel Alignment Method for Collimator Based on Laser Differential Confocal Technique

Misalignment effects of cross-phase grating lateral shearing interferometer and its alignment technique

Image acquisition and motion positioning system design based on the projection lens wavefront aberration measurement

Correlation Matching Method For High-Precision Position Detection Of Optical Vortex Using Shack-Hartmann Wavefront Sensor

A High-Precision Five-Degree-Of-Freedom Measurement System Based on Laser Collimator and Interferometry Techniques

Analysis of the Pinhole Array Illumination Source for High Precision Wavefront Error Metrology

A New Method to Measure Low-Order Aberrations Based on Wavefront Slope

Research on the Method of Interferometric-Spatial-Phase for the Alignment of Lithography

Differential Confocal Self-Collimation Method for High-Accuracy Measurements of Lens Decentration

Calibration of the Astigmatism Errors Induced by Misalignment of Quadri-Wave Lateral Shearing Interferometer

Laser Confocal Auto-Collimation Decentration Measurement for Spherical Lens

Wavefront Sensorless Aberration Correction Utilizing SPGD Algorithm with Adaptive Coefficient for Laser Scanning Confocal Microscopy

Laser Scanning Confocal Image Alignment Assists Sub-micron Accuracy Micro-assembly