Effect of Cooling Rate on Magnetostriction Gradients of Tb0.27Dy0.73Fe1.95 Alloys Solidified in High Magnetic Field Gradients

Tie Liu,Peng-Fei Gao,Meng Dong,Yu-Bao Xiao,Qiang Wang
DOI: https://doi.org/10.1063/1.4944079
IF: 1.697
2016-01-01
AIP Advances
Abstract:In this work, Tb0.27Dy0.73Fe1.95 alloys were solidified in a high magnetic field gradient (8.8 T, -565 T2/m) at various cooling rates. Changes in the magnetostriction, crystal orientation, and magnetization of the alloys were investigated. The application of the magnetic field gradient has a strong influence on the magnetostrictive performance. At lower cooling rates, the maximum magnetostriction increases gradually with depth from the top surface of the alloys. However, the effect of the magnetic field gradient is strongly dependent on the cooling rate. With increasing cooling rate, the magnetostriction gradient decreases. The magnetization measurement shows that the saturation magnetization at lower cooling rates increases gradually with depth from the top surface of the alloys. However, with increasing cooling rate, the increase in the saturation magnetization is reduced. The XRD measurement results show that the orientation behavior of the (Tb, Dy)Fe2 phase exhibits a continuous change throughout the alloys at lower cooling rates, but is almost unchanged at higher cooling rates. The change in the magnetostriction of the alloys can be attributed to the changes in crystal orientation and the amount of the (Tb, Dy)Fe2 phase in the alloys caused by both the magnetic field gradient and cooling rate.
What problem does this paper attempt to address?