Investigation of dwell time effects on the creep- fatigue-interaction behavior of a 1000 mw steam turbine rotor using a continuum damage mechanics- based viscoplastic model
Weizhe Wang,Yingzheng Liu
2017-01-01
Abstract:Creep-fatigue-interaction behavior is dominant in steam turbine rotors during the startup, steady state operation and shutdown phases, and steady state dwell time length is one of most important factors in power plant operation. Thus, the creep-fatigue-interaction behavior of steam turbine rotors under different dwell times was numerically investigated. Toward this end, continuum damage mechanics (CDM) was used to describe the coupling of creep and fatigue damage, and a CDM-based viscoplastic constitutive model was presented to describe creep-fatigue-interaction behavior. Uniaxial and multiaxial creep-fatigue tests were also conducted to validate the material model. Good agreement was achieved between the simulated and measured results. Further application of the material model to the steam turbine rotor illustrated that thermal stress dominated structures were sensitive to fatigue behavior, which easily accelerated the damage development. Moreover, thermo-mechanical loaddominated structures sustained damaged from the creep behavior much more easily. Thus, controlling the dwell time length significantly influenced the creep-fatigue-interaction behavior of the steam turbine rotors. INTRODUCTION As steam pressure and temperature increase, the viscous properties within the plastic range play an important role in the creep behavior of steam turbine components. Furthermore, the electricity market’s increasing demand for frequent startup-shutdown and the intermittent operation of large-capacity power plants pose continuous challenges to the safe operations of complex components, e.g., steam turbine rotors, under creep-fatigue-interaction behavior. Hence, steam turbine rotors suffer not only from the rapidly induced damage that results from the startup and shutdown cycles, but also from creep damage under sustained loading. When the rotors operate long term under full load conditions, the demand for more flexible operation determines the significance of dwell time length to the creep-fatigueinteraction behavior. Moreover, simultaneous creep and fatigue prompts consideration of the interaction between creep and fatigue behavior in a more accurate analysis of component strength. Thus, analytical predictions of dwell time’s effect on structural strength under creep-fatigueinteraction behavior are of great practical importance in the design of steam turbine rotors. Numerous studies have attempted to determine dwell time’s effects the creep-fatigue behavior of components. Stubbington and Pearson1 indicated that while the commercial aviation industry experienced distinct failures such as disk bursts due to dwell time effects, creep-fatigue interaction was typically the cause of failure among power plant components (Stubbington, 1978). Goswami and Hanninen (2001) thus experimentally studied the different effects of dwell time on high-temperature fatigue behavior and damage. Zrnik et al.(2001) experimentally investigated the influence of hold time on the deformation behavior of