Abstract:The paper presents a technique to obtain an electrically-tunable matching between the series and parallel resonant frequencies of a piezoelectric MEMS acoustic transducer to increase the effectiveness of acoustic emission/detection in voltage-mode driving and sensing. The piezoelectric MEMS transducer has been fabricated using the PiezoMUMPs technology, and it operates in a plate flexural mode exploiting a 6 mm × 6 mm doped silicon diaphragm with an aluminum nitride (AlN) piezoelectric layer deposited on top. The piezoelectric layer can be actuated by means of electrodes placed at the edges of the diaphragm above the AlN film. By applying an adjustable bias voltage Vb between two properly-connected electrodes and the doped silicon, the d31 mode in the AlN film has been exploited to electrically induce a planar static compressive or tensile stress in the diaphragm, depending on the sign of Vb, thus shifting its resonant frequency. The working principle has been first validated through an eigenfrequency analysis with an electrically induced prestress by means of 3D finite element modelling in COMSOL Multiphysics®. The first flexural mode of the unstressed diaphragm results at around 5.1 kHz. Then, the piezoelectric MEMS transducer has been experimentally tested in both receiver and transmitter modes. Experimental results have shown that the resonance can be electrically tuned in the range Vb = ±8 V with estimated tuning sensitivities of 8.7 ± 0.5 Hz/V and 7.8 ± 0.9 Hz/V in transmitter and receiver modes, respectively. A matching of the series and parallel resonant frequencies has been experimentally demonstrated in voltage-mode driving and sensing by applying Vb = 0 in transmission and Vb = −1.9 V in receiving, respectively, thereby obtaining the optimal acoustic emission and detection effectiveness at the same operating frequency.

Electrical Thermal Acoustic Point Source Based On Mems Technology

A Point Acoustic Device Based on Aluminum Nanowires

Progress of MEMS acoustic emission sensor: a review

Sound pressure and low frequency enhancement using novel pzt mems microspeaker design

PIEZOELECTRIC MEMS MICROSPEAKER WITH SUSPENSION SPRINGS AND DUAL ELECTRODE TO ENHANCE SOUND PRESSURE LEVEL

A Mems Acoustic Particle Velocity Sensor Based on Electrochemical Method

On the Design of Piezoelectric MEMS Microspeaker for the Sound Pressure Level Enhancement

Flexible Two-Dimensional Ti3C2 MXene Films as Thermo-Acoustic Devices.

The Recent Progress of MEMS/NEMS Resonators

Design of the MEMS Piezoresistive Electronic Heart Sound Sensor

Multichannel Piezo‐Ultrasound Implant with Hybrid Waterborne Acoustic Metastructure for Selective Wireless Energy Transfer at Megahertz Frequencies

An Aln-Based Piezoelectric Micromachined Ultrasonic Transducer with a Double-Beam Suspended Structure

Design Optimization of Surface Acoustic Wave Devices and Investigation of Fabricated Devices under Temperature, Humidity and Steam Environments

An Aln-Based Piezoelectric Micro-Machined Ultrasonic Transducer (Pmut) Array

Monolithic Integration of PZT Actuation Units of Various Activated Resonances for Full-Range Mems Speaker Array

Design of a Novel Medical Acoustic Sensor Based on MEMS Bionic Fish Ear Structure

Demonstration of MHz piezoelectric micromachined ultrasonic transducers array and its potential application for biomedical treatment

An ultrasound-induced wireless power supply based on AlN piezoelectric micromachined ultrasonic transducers

Low Frequency Sound Pressure Level Improvement Of Piezoelectric Ems Microspeaker Using Novel Spiral Spring With Dual Electrode

Localized Topological States beyond Fano Resonances via Counter-Propagating Wave Mode Conversion in Piezoelectric Microelectromechanical Devices

Piezoelectric MEMS Acoustic Transducer with Electrically-Tunable Resonant Frequency