Abstract:Because of higher power density and blocking voltage for Silicon Carbide (SiC) devices, careful insulation design is of much importance for future medium voltage power converters. Due to the insulation or mechanical coordination, surface defects (metal-insulation-air interface problem) inside the converters or high voltage PCB boards cannot be avoided. It is undeniable that the final design should be Partial Discharge (PD) free under normal operation with a safety margin. However, the traditional PD detection method could be ineffective or insensitive because of the serious disturbance of displacement current under fast rising repetitive square voltage, which leads to great difficulty in PD-based insulation assessment. Moreover, PD characteristics and mechanism of surface defects under PWM-like voltage, which contribute to guide the insulation design, also has not been understood clearly. For these purposes, this paper proposes a Silicon Photomultiplier (SiPM) based optical PD detection method firstly, which is suitable for offline or online PD detection and diagnosis under PWM-like voltage because of the advantages of small size, high gain, good sensitivity and high Electromagnetic Interference (EMI) immunity. Then, PD characteristics of artificial surface discharge model under PWM-like excitation are investigated and the relationship between the PD activities (average discharge magnitude and repetition rate) and the PWM-like excitation parameters (rising time, amplitude and frequency) has been explored. Finally, the proposed SiPM sensor is used for the insulation design and assessment of HV differential mode inductor. Experimental results indicate that space charge accumulation plays a great role in the surface discharge under PWM-like excitation.

A Novel Sinusoidal Damped Oscillating Voltage Generator for the Detection of Partial Discharge in MV Distribution Power Cables

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Development of Damped Ac Voltage Generator for the Partial Discharge Detection of Distribution Power Cables

A Novel Oscillation Wave Test System for Partial Discharge Detection in XLPE Cable Lines

Radio-frequency Detection of Partial Discharge in Power Cable Joints

A Novel Variable-frequency Resonant System for Partial Discharge Detection of XLPE Cables

Development of a 20 Kv Damped Oscillating Voltage Generator

A Novel DAC Generator for PD Testing of MV Cable Insulation

On-site Partial Discharge Detection of Power Cables Using a Novel DAC Technique Supplied by a Capacitor Bank

An Improved Design of Damped AC Test System for Partial Discharge Measurement in Distribution Power Cables

Novel dual‐resonance damped alternating current testing system for offline partial discharge measurement of power cables

Implementation of A Novel Double-Side Technique for Partial Discharge Detection and Location in Covered Conductor Overhead Distribution Networks

Development of a Novel 20 Kv 0.1 Hz Very Low Frequency Cosine-Rectangular Voltage Generator for Multi-Functional Insulation Testing of MV Power Cables

A Novel Approach to Partial Discharge Detection Under Repetitive Unipolar Impulsive Voltage

Partial discharge detection on power equipment using a magneto-resistive sensor

Partial Discharge Detection and Assessment of Surface defects under Fast Rising Repetitive Square Voltage for MV Converter Application

A Cost-Effective Technique for PD Testing of MV Cables under Combined AC and Damped AC Voltage

Development of A Portable Detecting System for Partial Cable Discharge

DSP Based On-Line Partial Discharge Monitoring System for High Voltage Power Cable

An Improved Variable-Frequency Series Resonant System for PD Detection of MV Power Cables Based on DAC Technology

A Novel Partial Discharge Locating System for 10-Kv Covered Conductor Lines in Distribution Network